Instead of getting another hub, you could simply get a power supply with the same plug (and polarity) but with a higher current capacity. I got some cheap 10 port USB2.0 hubs, replaced the original (2A) power supply with a 4A units (this should be capable of supporting 8 BE's per hub, but currently only have 6 on a hub). Note that if you run a USB powered fan(s), that uses power too that needs to be accommodated by the hub's power capacity. The hubs USB data connection are daisy-chained (one hub feeds into another, which then connects to a single port on the PC), this works fine with BFGMiner. The latest BFGMiner version (3.2.0) has a significantly lower HW error rate than earlier versions.
Cheers
Topic: Not enough hash rate with my USB block erupters. Power problem or Pool problem? (Read 959 times)
September 14, 2013, 08:08:56 AM
September 13, 2013, 10:11:54 AM
How long did you wait before you decided the hash rate was too low on the pool? it takes about and hour to catch up.
September 13, 2013, 06:56:13 AM
What version of bfgminer are you using?
September 13, 2013, 03:45:50 AM
2.5A is only enough to power 5 BE's, If you want to run the rest your going to need another HUB.
September 12, 2013, 06:28:54 PM
I have about 8 ASIC USB Block erupters which I ordered from BTC guild over time. I have a plugable USB powered 10-port Hub to which I've hooked up these 8 ASICs. I'm mining bitcoins from Slush's pool, but it shows that I only have a hash rate of 1370 MH/s instead of the expected 2640 MH/s.
The power ratings on my hub's adapter are as follows.
All devices' LEDs are blinking as they should and all 8 devices are recognized by BFGminer. All 8 devices show the hashrate they should, on BFG miner.
So, does the problem lie with my devices or the pool? Am I mining the right amount of bitcoins?
The power ratings on my hub's adapter are as follows.
Code:
Input 200-240 V, 50/60 Hz 0.5 A
Output 5V, 2.5 A
I'm not sure if this will help, but these are the parameters I use with BFG Miner.Output 5V, 2.5 A
Code:
-G -S all --icarus-options 115200:1:1 --icarus-timing 3.0=100
All devices' LEDs are blinking as they should and all 8 devices are recognized by BFGminer. All 8 devices show the hashrate they should, on BFG miner.
So, does the problem lie with my devices or the pool? Am I mining the right amount of bitcoins?
Jump to: