Topic: Only Half of my TerraMiner IV is mining :( (Read 1177 times)
This is a very common problem that cointerra is very well aware of.
Let me ask you this question:
Was your rig ever on a public ip address? If so it may very well be compromised and the other core is mining for someone else without you knowing.
I have gone though this ordeal and had to un-hack about 92 cointerra rigs.
The process to unhack them is something I cannot post here or it could cause more peoples boxes to become hacked so I wont post it
however I can un-hack it for you or help you.
If you have cointerra boxes, I specialize in them and if you host them at my facility I can assure you they will be secure and safe from hackers.
skype: host.wanted
Hi everyone
Ever since I've received my Terraminer IV in the mail, I've only seen 1 core (CTA0) recognized in the web interface. The unit only mines at 700-800 Gh/s which confirms the fact that only one core is working. I believe it's the core controlled by the lower plug on the unit because if I don't connect the top plug it makes no difference in the operation of the miner.
I've posted all the data from the stats page at http://bl.ocks.org/yskywalker/raw/e979fd6032da76835303/ (It was too large to put on this post) I'm also posting my cgminer.log at https://gist.github.com/yskywalker/db685aa5413f39d394d0 (That log came from relaunching cgminer with the --debug option.)
Once, I plugged in the lower plug first, waited 5 minutes, then plugged in the upper plug. Both miners started working but CTA1 wouldn't go over 500Gh/s. Another time CTA1 showed up but didn't do any mining. When that happened, the temperature was reading a huge negative value. I also noticed that the logfile mentioned disabling a core because no temp sensor was detected. That doesn't show up in my logfile anymore because the other core isn't detected at all.
Thanks in advance for any suggestions. I have no problem running cgminer with specific commands or doing anything else through ssh.
Ever since I've received my Terraminer IV in the mail, I've only seen 1 core (CTA0) recognized in the web interface. The unit only mines at 700-800 Gh/s which confirms the fact that only one core is working. I believe it's the core controlled by the lower plug on the unit because if I don't connect the top plug it makes no difference in the operation of the miner.
I've posted all the data from the stats page at http://bl.ocks.org/yskywalker/raw/e979fd6032da76835303/ (It was too large to put on this post) I'm also posting my cgminer.log at https://gist.github.com/yskywalker/db685aa5413f39d394d0 (That log came from relaunching cgminer with the --debug option.)
Once, I plugged in the lower plug first, waited 5 minutes, then plugged in the upper plug. Both miners started working but CTA1 wouldn't go over 500Gh/s. Another time CTA1 showed up but didn't do any mining. When that happened, the temperature was reading a huge negative value. I also noticed that the logfile mentioned disabling a core because no temp sensor was detected. That doesn't show up in my logfile anymore because the other core isn't detected at all.
Thanks in advance for any suggestions. I have no problem running cgminer with specific commands or doing anything else through ssh.
Jump to: