Topic: Problem with ASIC Blades not connecting (Read 1009 times)
did you remember to change the IPs of the miners?
Dont forget to set up stratum proxy if you are trying to connect to a pool that needs stratum
You don't need a crossover cable. Though that shouldn't matter if your switch is auto-sensing.
Does your PC and the blade have the same IP address set for the gateway? If your PC can access the internet that one is correct.
Does your PC and the blade have the same IP address set for the gateway? If your PC can access the internet that one is correct.
Hi
i could do with some help my friends
I recently bought 3 blades from the group buy
they arrived last thursday and since then i have been ripping my hair out
They turn on and have all O's on the screen
But they dont seem to be hashing
I have attempted to set up as according to the guide in the forums
But soon as i change the settings all the 0's turn to x's and it wont connect
i have tried 5 different power supplys
using a xover cable direct to my router and through a switch
do i need to use a straight network cable?
i could do with some help my friends
I recently bought 3 blades from the group buy
they arrived last thursday and since then i have been ripping my hair out
They turn on and have all O's on the screen
But they dont seem to be hashing
I have attempted to set up as according to the guide in the forums
But soon as i change the settings all the 0's turn to x's and it wont connect
i have tried 5 different power supplys
using a xover cable direct to my router and through a switch
do i need to use a straight network cable?
Jump to: