well it's acting up again. usually happens when the rig's been running over 12 hours
not displaying web interface on any PC but the mining rig
underclocked, stock voltage, using deepbit. web interface showed working but deepbit went down to 0mhash
Topic: Problem with Board? BAMT keep saying GPU have fault, stop hashing (Read 1900 times)
Okay, I've been downclocking the cards over and lover, they're under stock (3x 5970's) and BAMT keeps saying a fault
THIS time it was on ALL cards. the temperature was reading about 70C or less, I had a fan blowing over the open board
I'm thinking either a board problem or PSU, both are new, only used for a week
ASUS P8B WS C206
1200W Cooler Master Silent Pro
It seems to mine fine for 4-12 hours then gives errors, didn't feel like southbridge or motherboard VRM (not sure if thats right) were VERY hot
what could i do to check MB or how to check PSU? I have a multimeter, checked one reail the other time and it was 11.96v stable when the rig was running, but i tink the rail was different than the ones i had GPU's on, WAIT actually the PSU: Single +12V rail up to 98A.
ALso, got a kernel error;
"Your system had a kernel failure there is diagnostic information available for this failure"
next time I'll save the error text
EDIT:
Okay I understand helping me is against your best interest and profit
running fine now it seems, changed pit.deepbit back to f2.deepbit, miners were disconnecting, do have some restarts with bamt though, assume random errors like winxp has, i switched to another drive, but still gives me fs.sh error (yellow text) on BAMT startup
THIS time it was on ALL cards. the temperature was reading about 70C or less, I had a fan blowing over the open board
I'm thinking either a board problem or PSU, both are new, only used for a week
ASUS P8B WS C206
1200W Cooler Master Silent Pro
It seems to mine fine for 4-12 hours then gives errors, didn't feel like southbridge or motherboard VRM (not sure if thats right) were VERY hot
what could i do to check MB or how to check PSU? I have a multimeter, checked one reail the other time and it was 11.96v stable when the rig was running, but i tink the rail was different than the ones i had GPU's on, WAIT actually the PSU: Single +12V rail up to 98A.
ALso, got a kernel error;
"Your system had a kernel failure there is diagnostic information available for this failure"
next time I'll save the error text
EDIT:
Okay I understand helping me is against your best interest and profit
running fine now it seems, changed pit.deepbit back to f2.deepbit, miners were disconnecting, do have some restarts with bamt though, assume random errors like winxp has, i switched to another drive, but still gives me fs.sh error (yellow text) on BAMT startup
Jump to: