Since OP mentioned that it used to run at full speed, I doubt a cable randomly disconnected.
I would rather bet on the fact that one of your blade died, it will need to be replaced or repaired.
IMO, I doubt it would be worth doing so with the current difficulty.
Topic: problem with S3 antminer (Read 590 times)
Looks like you have a bad blade.
Open it and make sure your cables a correctly connected.
Inspect and smell for burns.
Open it and make sure your cables a correctly connected.
Inspect and smell for burns.
Also do you have both plugs plugged in? And what model/brand PSU are you using?
And also when you do your inspecting make sure to turn it off and unplug it. Might run it after with hood off just be careful with inspecting as then it would have live electricity going through it.
Looks like you have a bad blade.
Open it and make sure your cables a correctly connected.
Inspect and smell for burns.
Open it and make sure your cables a correctly connected.
Inspect and smell for burns.
I have an S3 where previously had a speed of 430 GH / S but overnight low working speed 220 GH / S someone could help me with this problem?
I am new to mining. I gave reset the computer, you change the source of power (1200W) and continues with the same problem.
I am new to mining. I gave reset the computer, you change the source of power (1200W) and continues with the same problem.
Jump to: