Question regarding electronics | Bitcointalksearch.org

Newar

legendary

Activity: 1358

Merit: 1001

https://gliph.me/hUF

Hm, since there is a risk of destroying some of your equipment and I'm still not sure if I understand you correctly, I will not comment just yet. Cool

Can you maybe post a picture of the equipment involved? What to you want to connect to which? Are you talking about something like this as your second PSU? https://upload.wikimedia.org/wikipedia/commons/thumb/7/7f/Wall-Wart-AC-Adapter.jpg/800px-Wall-Wart-AC-Adapter.jpg

FlutterPie

full member

Activity: 177

Merit: 100

Quote from: Newar on June 30, 2014, 12:15:04 AM

If I understand you correctly...

This depends if your PSU is powerful enough for the additional equipment you want to run. Check the watt numbers. Don't push it too high and leave some reserve.

If you use your own cables, make sure their gauge is big enough for the needed current.

Also, make sure you get positive and negative right (polarity) Wink

Thank you, Im probably not good at explaining things. I was talking about how the 3 that are running currently are running off a PSU. The 4th I will not be able to connect to the PSU.

I actually cut off the plug from an old electronic. So I have the part that plugs into the wall and wires at the other end.

If I match the positive and negative on the barrel connector to the plug, solder the barrel connector to the plug. Would that work just fine?

Newar

legendary

Activity: 1358

Merit: 1001

https://gliph.me/hUF

If I understand you correctly...

This depends if your PSU is powerful enough for the additional equipment you want to run. Check the watt numbers. Don't push it too high and leave some reserve.

If you use your own cables, make sure their gauge is big enough for the needed current.

Also, make sure you get positive and negative right (polarity) Wink

FlutterPie

full member

Activity: 177

Merit: 100

So I have a few bitcoin miners that require barrel connectors. I have 3 setup currently. Here is a question, I have the barrel connectors, can I just solder the barrel connectors to a plug which I cut off something else. Plug in the bitcoin miner and expect it to work without a problem?

The 3 I have going now are hooked up to a PSU. And unless I wanted to basically destroy it I can't hook up more. The miners require 12 volts. So if I just solder a plug to the barrel connector, the miner should only pull what it needs (12 volts) and it should work right?

Topic: Question regarding electronics (Read 800 times)