This guide is based on a linux system. Commands on windows might differ from them.
Commands on Windows don't exist as there is no Electrum daemon for Windows... and you cannot use commandline options like you can use on Linux. 
Topic: RPC username and password (Read 218 times)
You need to run this commands in a command line, not in the electrum console.
The required steps are outlined in this guide: http://docs.electrum.org/en/latest/merchant.html
This guide is based on a linux system. Commands on windows might differ from them.
Anyway, it is recommended to run a webserver on a linux machine (for security reasons).
The required steps are outlined in this guide: http://docs.electrum.org/en/latest/merchant.html
This guide is based on a linux system. Commands on windows might differ from them.
Anyway, it is recommended to run a webserver on a linux machine (for security reasons).
how i will start daemon
i did set rpcuser and pass and port. next i willl put this command create() , its shows error msg and also tried daemon command , how can i start daemon ?
https://prnt.sc/j9ck81
http://prntscr.com/j9ckfk
please check this screenshorts.
i did set rpcuser and pass and port. next i willl put this command create() , its shows error msg and also tried daemon command , how can i start daemon ?
https://prnt.sc/j9ck81
http://prntscr.com/j9ckfk
please check this screenshorts.
You can't 'find' your RPC username and password, you have to set one first.
In the console (to set port, username and password):
Then start the daemon and load your wallet file:
In the console (to set port, username and password):
Code:
electrum setconfig rpcport 7777
electrum setconfig rpcuser "username"
electrum setconfig rpcpassword "password"
electrum setconfig rpcuser "username"
electrum setconfig rpcpassword "password"
Then start the daemon and load your wallet file:
Code:
electrum daemon start
electrum daemon load_wallet
electrum daemon load_wallet
How can i find RPC username and password in electrum
and how will i config
in my code?
and how will i config
in my code?
Jump to: