Did you email their support? They got back me somewhat quickly. Did you try re-flashing with the S3+ firmware and make sure to uncheck "save settings" again? This may resolve the issue...
Problem solved. I think the 4 pin connector terminal on the new board was not fully seated. It appears to be working properly now. 
Topic: S1 to S3 Upgrade hashing speed off - HELP (Read 1427 times)
Did you email their support? They got back me somewhat quickly. Did you try re-flashing with the S3+ firmware and make sure to uncheck "save settings" again? This may resolve the issue...
Think I'll join in with your thread. Mines not hashing at all, showing 4 chains:
I reflashed the unit and had the same results when I pointed the miner at BFG Miner 4.8.0 in proxy mode... I tried pointing the unit directly at GHASH and its hashing around 470 GH/s.
I guess there's some limitation in BFG Miner?
I guess there's some limitation in BFG Miner?
I installed one of the upgrades for the S1 to s3 and my unit is only hashing between 215 and 270GH/S. I flashes the ROM to antMiner_S320140826.bin.
I do not show temperature, fan 2 speed and my hash rate is slow. I also do not show a BestShare number, yet the unit has ben hashing for over 9 hours. I tried going directly to GHASH and also using BFG Miner in proxy mode, both yield the same results. I tried frequencies 250, 225 and 218.75.
What should I do next?
I do not show temperature, fan 2 speed and my hash rate is slow. I also do not show a BestShare number, yet the unit has ben hashing for over 9 hours. I tried going directly to GHASH and also using BFG Miner in proxy mode, both yield the same results. I tried frequencies 250, 225 and 218.75.
What should I do next?
Jump to: