Topic: s19 95Th not hashing after broken fan replacement (Read 89 times)
Thanks I’ll check it out and post my log if that doesn’t work.
Why not post the whole kernel logs here for a little bit of insight?
It might be a compatibility issue because the new fan that you replace will be forced to run around 7000rpm. If it's not compatible you smell like burn better replace them only with a compatible fan check this fan below from ZeusBTC
- https://www.zeusbtc.com/UsedMinerDetails.asp?ID=46
It might be a compatibility issue because the new fan that you replace will be forced to run around 7000rpm. If it's not compatible you smell like burn better replace them only with a compatible fan check this fan below from ZeusBTC
- https://www.zeusbtc.com/UsedMinerDetails.asp?ID=46
An inlet fan blade broke and i replaced the fan. Removed fan/screws -> opened the top and swapped the 4-pin connector -> installed new fan/screws. The fan make is Delta not the Nidec original (specs are the same.)
I was using Poolin and the miner had been offline a few days until i had time to replace the fan.
Turned the miner on once replacement was finished -> connected and started hashing ~10 Th/s then it dropped to 1 then to 0. I restarted the miner and smelt a little bit of ozone so i turned it off.
Any assistance is greatly appreciated.
I was using Poolin and the miner had been offline a few days until i had time to replace the fan.
Turned the miner on once replacement was finished -> connected and started hashing ~10 Th/s then it dropped to 1 then to 0. I restarted the miner and smelt a little bit of ozone so i turned it off.
Any assistance is greatly appreciated.
Jump to: