Topic: S2 Antminers won't connect to router with new settings: Request Networking help. (Read 1629 times)

Once you access them via you're laptop can you not just set them to DHCP so they auto configure?

If so then just check you're router to see what IP address they get assigned and access them through that.

You can then always reserve that IP in the router and they will always be assigned it.

Hope this helps

Thank you for your suggestion. I tried connecting to the router and the connection was correctly established. However, two of my S2 Antminers do not save their settings but the third one does.
Justin 

Is the miner actually saving the settings you enter? Why not connect it to the router instead of the macbook?

Friends:
I have three S2 Antminers that were successfully hashing when using the following settings:

hostname: antminer
Protocol: Static
IP Address: 192.168.168.254 (99, 97)
Netmask: 255.255.255.0
Gateway: 192.168.168.168
DNS Servers: 192.168.168.168

After a visit by the Comcast/Xfinity technician to fix a failed modem yesterday, the settings for my router and its three bridge extenders (to adequately cover the house and back yard) have changed and the above listed settings no longer work.

The new settings for the routers vary in the subnet mask, one having 255.255.248.0 and the other three having 255.255.255.0

The current settings for the four Apple routers:

Tall  Time Capsule (connected directly to the Xfinity modem)
IPv4 Address: 24.16.152.98
Subnet Mask: 255.255.248.0
Router Address: 24.16.152.1
DNS Servers: 75.75.75.75, 75.75.76.76

Airport Extreme (Bridge)
IPv4 Address: 10.0.1.5
Subnet Mask: 255.255.255.0
Router Address: 10.0.1.1
DNS Servers:10.0.1.1

Family Room Airport Extreme (Bridge)
IPv4 Address: 10.0.1.10
Subnet Mask:255.255.255.0
Router Address: 10.0.1.1
DNS Servers: 10.0.1.1

Flat Time Capsule (Bridge)
IPv4 Address: 10.0.1.11
Subnet Mask: 255.255.255.0
Router Address: 10.0.1.1
DNS Servers:10.0.1.1

My question: Given the above settings, what settings should I use to give my S2 Antminers access to the Internet and the various pools? I am able to connect any of the three to my MacBook Pro and access it by using 192.168.1.99 just as it states in the manual. However, once I had entered new settings and connected the S2 to the router by ethernet cable, the S2 displayed an IP address of 127.0.0.1

I appreciate any suggestions to help me resolve this issue.
Thank you,
Justin