Topic: S3 issue 2 days after upgrade (Read 901 times)
Bump
The LED next to C31 is flashing green. Nothing happens when holding down the reset button S2 for 3 seconds or more.
Thanks, but I've tried flashing with:
antMiner_S320140711.bin
antMiner_S320140811.bin
antMiner_S320141024.bin
antMiner_S320141126.bin
Both with "Keep Settings" checked and unchecked.
Do you think that a reset will address this?
antMiner_S320140711.bin
antMiner_S320140811.bin
antMiner_S320141024.bin
antMiner_S320141126.bin
Both with "Keep Settings" checked and unchecked.
Do you think that a reset will address this?
Known problem with the newest firmware, either revert to a firmware before the Oct. firmware (reset button doesn't work with it) or you can try to set the voltage settings to 0725 (with the Nov. firmware), save and apply and then reboot. Watch to see if that help, if not then use a different firmware and all should go back to normal.
I have 5 S3 units that I upgraded, for some reason I got lazy and didn't get around to upgrading the last unit until this past Sunday. I used the most recent flash "antMiner_S320141126.bin" and everything ran fine for the last 2 days. I noticed that the speed was winding down when I went to look at my control panel on a pool that I was mining. I've since re-flashed numerous times both with "keep" and "do not keep" the current configuration checked. I have also ran the unit on a known good power supply, tried pointing the unit to all of the pools that I use and I still have issues. The unit no longer shows either chain information. I reset all of the wires on the unit, left it unplugged for 2 hours and I still encounter the same issue... Any thoughts?
Jump to: