S7 Miner Hashing issue | Bitcointalksearch.org

BitMaxz

legendary

Activity: 3374

Merit: 3095

Playbet.io - Crypto Casino and Sportsbook

Quote from: after9mining on March 05, 2018, 10:36:43 PM

Still getting those x's but different spots and different boards with each reset

It might be a hardware if everything in software not working like ccgllc said it may be dying. For now better to adjust and lower the frequency of your miners, like what you said before it is working with adjusting frequency and fan. So, for now, this is the only best solution.

If you want to do hardware it would be riskier than software.

Anyway I wanted to share this thread it might be helpful for repairing s7 miner https://bitcointalksearch.org/topic/cheap-and-simple-repair-of-s7-hash-board-1420909

ccgllc

copper member

Activity: 658

Merit: 101

Math doesn't care what you believe.

Either lower the frequency and hope the chips can handle it, live with it, or declare your S7 as dying. Typically knocking the frequency back a bit helps in this situation.

Of course, we are presuming adequate power and good cooling.

after9mining

newbie

Activity: 3

Merit: 0

Still getting those x's but different spots and different boards with each reset

after9mining

newbie

Activity: 3

Merit: 0

Thanks. Ill give that a try. I did get the other board running. On a board somewhere in my travels trying to fix this. It was mentioned to change to fans to 50% and adjust the frequency. This did get things working however I found that once the board came online I can see some errors. oooooooo oooxo oooooooo xooooooo oooooooo oooooooo they come and go if I power cycle.

BitMaxz

legendary

Activity: 3374

Merit: 3095

Playbet.io - Crypto Casino and Sportsbook

If you have extra miner with the same PSU you can switch them and test it if it is PSU's issue, if still issue persist better to do software first before you go to the hardware.

You may try to reflash and replace a new firmware from bitmain check the firmware list here
https://shop.bitmain.com/support.htm?pid=00720160511022802617GoPmQhNb06CF
Just go to the upgrade dashboard of your antminer s7 then choose the downloaded firmware and upgrade.

If still not working you can try to run hashing board 1 by 1 with the same cable and check if what hashing board is damaged, then if they're running fine without issue in the same cable maybe its connection issue with the cable try to change the damaged cable.

Hope that you get some idea.

Just adding this for future troubleshooting
https://support.bitmain.com/hc/en-us/articles/220872007-Possible-problems-for-Antminer-Troubleshooting-for-S7-S9-L3-

after9mining

newbie

Activity: 3

Merit: 0

I have a issue with my middle board. When powering up all three boards light up for the entire power cycle. Once the machine cycles I lose the middle hashing board. The red light doesn't light up. When checking the miner software it shows the same chips as the other two and the same frequency. The temperature is at 12 while the other 2 are at 45. All three in the status section show oooooooo ooooo oooooooo oooooooo oooooooo oooooooo.
It shows that it can get power but loses it after the power cycle. I tried to search the forum but came up with many things that were similar but not the same. I,ve changed out the wiring to the boards but this didnt change the outcome. Any ideas?

Topic: S7 Miner Hashing issue (Read 207 times)