Topic: SimpleMining OS & Eth & Nanopool (Read 238 times)
Configure the miners and wallet address from the group. Assign your rig into the group. Then reload the miner program.
hi,
I did the same test to change from Dwarfpool to nanopool.
I used the following config:
-wd 1 -r 1 -epool stratum+tcp://eth-eu1.nanopool.org:9999 -ewal 0x.../rig1/myEmailAddress -mode 1 -esm 0 -asm 1 -allpools 1 -mport 127.0.0.1:3333
Rig is starting and sends share to nanopool.
Then log into nanopool and wait a bit until rig appears in the list.
works fine.
I did the same test to change from Dwarfpool to nanopool.
I used the following config:
-wd 1 -r 1 -epool stratum+tcp://eth-eu1.nanopool.org:9999 -ewal 0x.../rig1/myEmailAddress -mode 1 -esm 0 -asm 1 -allpools 1 -mport 127.0.0.1:3333
Rig is starting and sends share to nanopool.
Then log into nanopool and wait a bit until rig appears in the list.
works fine.
Hello, I am using SimpleMining OS to mine Ethereum to Nanopool. I have got the mining set up fine, but when I check my progress on Nanapool it always says "Incorrect Worker Name". I am using claymore-eth-v10.6 within SMOS.
I thought I have set it up properly in SMOS, the line being:
Default config: -wd 1 -r 1 -epool stratum+tcp://eth-eu.dwarfpool.com:8008 -ewal $walletETH/$rigName -esm 0 -epsw x -allpools 1 -asm 1
I have changed the stratum address to nanopool and put my Eth Wallet address in, but I have tried putting a rig name in afterwards and Nanopool doesn't like it at all it seems.
The auto generate config file for Claymores miner from NP i:
-epool eth-eu1.nanopool.org:9999 -ewal [WALLET ADDRESS].Rig1/[EMAIL ADDRESS] -epsw x -mode 1 -ftime 10
Which I have also tried with no success.
I hope there will be no issue with NP and me losing a payout over this? It has registered fine with my walled address.
I realise this is probably a beginners question but if anyone could point me in the right direction that would be much appreciated - I'm going round in circles here.
Thank you.
I thought I have set it up properly in SMOS, the line being:
Default config: -wd 1 -r 1 -epool stratum+tcp://eth-eu.dwarfpool.com:8008 -ewal $walletETH/$rigName -esm 0 -epsw x -allpools 1 -asm 1
I have changed the stratum address to nanopool and put my Eth Wallet address in, but I have tried putting a rig name in afterwards and Nanopool doesn't like it at all it seems.
The auto generate config file for Claymores miner from NP i:
-epool eth-eu1.nanopool.org:9999 -ewal [WALLET ADDRESS].Rig1/[EMAIL ADDRESS] -epsw x -mode 1 -ftime 10
Which I have also tried with no success.
I hope there will be no issue with NP and me losing a payout over this? It has registered fine with my walled address.
I realise this is probably a beginners question but if anyone could point me in the right direction that would be much appreciated - I'm going round in circles here.
Thank you.
Jump to: