Yes, ofcourse with access trough SSH - older firmware.
And also without having to install braiins.
Static "Fault" Led light is what I was thinking if there was any command for this.
Topic: Static Red light by SSH (Help) (Read 153 times)
Is there a command to put static red light by SSH on Antminer S9/s9i ? I've been struggling to figure out.
You can control the LED lights with BraiinsOS, or force them to blink or not to identify units.
Identifying a miner in a farm
The local miner utility can also be used to identify a particular device by enabling aggressive blinking of the red LED:
$ miner fault_light on
Similarly to disable the LED run:
$ miner fault_light off
The local miner utility can also be used to identify a particular device by enabling aggressive blinking of the red LED:
$ miner fault_light on
Similarly to disable the LED run:
$ miner fault_light off
What do you mean by static red light?
Is it a red light from the hashboard?
If you are using 2019 firmware you don't have access on SSH unless if you are using below 2019 firmware.
Is it a red light from the hashboard?
If you are using 2019 firmware you don't have access on SSH unless if you are using below 2019 firmware.
Is there a command to put static red light by SSH on Antminer S9/s9i ? I've been struggling to figure out.
Jump to: