Topic: Technobit NanoFury USB bitcoin miner (Read 2426 times)
Thanks for your help you guys. bfgminer did the trick.
Hello fellow miners,
I just received my USB miners but I can't find a tutorial on how to setup them on Windows 8.
Can anyone help?
I just received my USB miners but I can't find a tutorial on how to setup them on Windows 8.
Can anyone help?
Hello
I guess this will make for a good start:
Sample usage instructions:
Get BFGMINER (edit: Luke-Jr suggested version 3.5.1)
sample command line:
bfgminer.exe -o stratum+tcp://mint.bitminter.com:3333 -u vs3_nanofury1 -p nanofury1 -G -S all --set-device NFY:osc6_bits=52
The last parameter overwrites the speed bits. A note of caution - the "safe" speed is around 50 bits, so anything over that will likely use more power than what the USB2.0 specs permit. No two chips are the same, so the upper limit will probably be different for each device. On my devices it was around 52-54.
Two things have been happening with my devices when I go over the limit - 1) when they overheat hashrate drops significantly - like 0.3-0.5GH, and 2) if the hub can't provide enough power (and voltage drops below 3.6-3.8V) that just ruins the USB communication and the device appears to have disconnect - beware that the bitfury chip will still have enough power (it needs 1V) and will continue to work even though the PC doesn't "see" the device, so you'll need to unplug it and plug it back in.
Please be careful when handling them - THEY WILL BE HOT!!! and especially even more if you push them. DO NOT TOUCH THE HEATSINKS when they work - heatsinks may reach over 80C!
Get BFGMINER (edit: Luke-Jr suggested version 3.5.1)
sample command line:
bfgminer.exe -o stratum+tcp://mint.bitminter.com:3333 -u vs3_nanofury1 -p nanofury1 -G -S all --set-device NFY:osc6_bits=52
The last parameter overwrites the speed bits. A note of caution - the "safe" speed is around 50 bits, so anything over that will likely use more power than what the USB2.0 specs permit. No two chips are the same, so the upper limit will probably be different for each device. On my devices it was around 52-54.
Two things have been happening with my devices when I go over the limit - 1) when they overheat hashrate drops significantly - like 0.3-0.5GH, and 2) if the hub can't provide enough power (and voltage drops below 3.6-3.8V) that just ruins the USB communication and the device appears to have disconnect - beware that the bitfury chip will still have enough power (it needs 1V) and will continue to work even though the PC doesn't "see" the device, so you'll need to unplug it and plug it back in.
Please be careful when handling them - THEY WILL BE HOT!!! and especially even more if you push them. DO NOT TOUCH THE HEATSINKS when they work - heatsinks may reach over 80C!
Cgminer doesn't support them. You will need to use bfgminer 3.5.1
if cgminer supports them then its as simple as downloading the latest cgminer using the zdaig (not sure how its spelt) use it to change the driver then run cgminer
Hello fellow miners,
I just received my USB miners but I can't find a tutorial on how to setup them on Windows 8.
Can anyone help?
I just received my USB miners but I can't find a tutorial on how to setup them on Windows 8.
Can anyone help?
Jump to: