Undervolting S9 for better efficiency

tim-bc

full member

Activity: 538

Merit: 175

You can use bmminer-mix to recompile bmminer.sh as you like. I wouldn't go much below 8.4V.

The definitions you need to edit are around line 588 of https://github.com/bitmaintech/bmminer-mix/blob/master/driver-btm-c5.c

Quote from: BitMaxz on August 08, 2018, 11:28:11 PM

I think it is not good to use some custom firmware because you don't have a chance to recover or reflash it back to its original firmware.

If you do what I've just described all you have to do is replace bmminer.sh, you can make a backup of the old one and restore whenever you like. Or, you can always go the upgrade section and flash it new again.

BitMaxz

legendary

Activity: 3472

Merit: 3217

Playbet.io - Crypto Casino and Sportsbook

I think it is not good to use some custom firmware because you don't have a chance to recover or reflash it back to its original firmware. There is some way that you can increase hashrate and lower your power consumption by editing the fan speed and frequency check this guide https://bitcointalksearch.org/topic/solution-for-antminer-s9-fans-speed-up-down-every-20-seconds-2690140

However, if you actually want to flash your miner with custom firmware there is board section here where you can find the new custom firmware.

Don't trust newbies pretending that they develop a s9 firmware because most of the custom firmware has backdoor or remote access and sucks your miners hashrate.
Here is the board section that I said https://bitcointalk.org/index.php?board=42.0

taserz

sr. member

Activity: 808

Merit: 294

Created AutoTune to saved the planet! ~USA

Quote from: vincl on August 08, 2018, 06:43:33 AM

Hey guys, i know there are custom firmwares out there to increase the voltage and use higher frequencies to get more hashrate with worse efficiency.

did someone managed to undervolt/underclock an S9 to gain a higher efficiency? i dont care about less hashrate, its only about efficiency.

i couldnt find anything on the internet about that. maybe someone of you was successfull?

Check my github I have a version that runs at 8.7v

vincl

member

Activity: 386

Merit: 18

Hey guys, i know there are custom firmwares out there to increase the voltage and use higher frequencies to get more hashrate with worse efficiency.

did someone managed to undervolt/underclock an S9 to gain a higher efficiency? i dont care about less hashrate, its only about efficiency.

i couldnt find anything on the internet about that. maybe someone of you was successfull?

Topic: Undervolting S9 for better efficiency (Read 372 times)