Will try to change the frequencies , but where is this done ?
And try to cleen it out this week
Thanks for the fast reply
Topic: Z11 temp to hig need reboot (Read 103 times)
Hey
Got a z11 used , it worked fine 2 month but now keep giving me a to hig temp on chip 111 close pic need reboot and stop mining until i reboot , after 2 min it will stop again.
Does it just need to be open op and maby remove dust?
If there is dust, then it is better to clean it, but I doubt that the fans do a poor job. Check the operating frequencies, if the ASIC is overclocked, then restore the factory settings and set up the mining pool again. Try to lower the frequencies, use an interval from 650 to 700. Got a z11 used , it worked fine 2 month but now keep giving me a to hig temp on chip 111 close pic need reboot and stop mining until i reboot , after 2 min it will stop again.
Does it just need to be open op and maby remove dust?
Cant hurt. I would use compressed air to blow of any dust from thr boards. Do not over spin the fans with the compressed air.
Hey
Got a z11 used , it worked fine 2 month but now keep giving me a to hig temp on chip 111 close pic need reboot and stop mining until i reboot , after 2 min it will stop again.
Does it just need to be open op and maby remove dust?
Got a z11 used , it worked fine 2 month but now keep giving me a to hig temp on chip 111 close pic need reboot and stop mining until i reboot , after 2 min it will stop again.
Does it just need to be open op and maby remove dust?
Jump to: