Zeus Miner GEN III Chip Blade "Blizzard X3"

darkkaplah

newbie

Activity: 1

Merit: 0

Quote from: 8bits on August 02, 2017, 02:54:40 PM

Hi I was able to get some "Zeus Miner GEN III Chip Blade" boards rather cheap I can deal with the case and the cooling situation. Although I'm at a loss with what to do with the 2 on board screw on adapters. Do I just clip a cable put a hook on the end of red and black and attach the thing? Any thoughts or ideas would be helpful thanks!

Hi,

Just curious where you purchased the boards from. I've got 6 blizzards with the original hardware that I'd like to upgrade. What did you wind up paying?

Also how are you handling the cooling if you don't have the original part? Have a photo of your solution?

8bits

newbie

Activity: 27

Merit: 0

I wish I could find a better picture of the blade but I think your correct as long as it's getting dc voltage on those two connectors, I should be fine. I'll just snip a connector remod it and attach it to the board
http://storeminer.com/wp-content/uploads/2016/08/29m.jpg. Good thing the boards take little voltage I think 40watt per so will use a bronze 650 or something

leowonderful

legendary

Activity: 1624

Merit: 1130

Bitcoin FTW!

Could you provide a picture of the blade and specifically where those attachments are? Pretty sure that's how it works with these things but I can't be sure without a clear pic. If I am right you can just wire a positive and negative cable up to those ends and it should power on given that the thing is connected to the controller and it is running 12V.

QuintLeo

legendary

Activity: 1498

Merit: 1030

Try in the Altcoin Mining section, I'm 99% sure those are Scrypt mining boards.

8bits

newbie

Activity: 27

Merit: 0

Hi I was able to get some "Zeus Miner GEN III Chip Blade" boards rather cheap I can deal with the case and the cooling situation. Although I'm at a loss with what to do with the 2 on board screw on adapters. Do I just clip a cable put a hook on the end of red and black and attach the thing? Any thoughts or ideas would be helpful thanks!

Topic: Zeus Miner GEN III Chip Blade "Blizzard X3" (Read 547 times)