ok, so I got another psu with the correct number of 6pin connectors and the two green and the red status light comes on, when I plug in the ether cord it flashes green and the yellow light comes on and stays on. hope that all good, now I put in the recomended address of 192.168.1.254:8000 get a time out response, I look at my ipconfig I get
subnet mask........ 255.255.255.0
defalut gateway.....192.168.2.1
err I'm confused as to what the address should look like?
I tried 192.168.2.254:8000 with no avail either
Topic: 30gh/s cube Help - page 2. (Read 2687 times)
i have both of mine plugged in
ok so there are two 6 pin power connection spots do I need to power both or just one with ample psu?
Im getting a power supply tonight, Ill keep you all posted thanks for the great links!
I think your right about 800 watts would be perfect Expecially since at over clock they run 280 watts allmost 300 so be on the safe side 
So you have to use 1 power supply per cube ?? Im thinking about getting 2 cubes just to run till febuary Pre-orders arrive . If i get a 600 watt power supply will it run 2 of them u think 
? Thx
. If i get a 600 watt power supply will it run 2 of them u think ? Thx a 600w *should run 2 if you use the low clock setting.... you dont want to run the psu at max watts constantly....
id suggest a 750w or 800w to run 2 in overclock mode....
So you have to use 1 power supply per cube ?? Im thinking about getting 2 cubes just to run till febuary Pre-orders arrive . If i get a 600 watt power supply will it run 2 of them u think ? Thx
. If i get a 600 watt power supply will it run 2 of them u think ? Thx
This one is dedicated to the BE Cube: https://bitcointalksearch.org/topic/guide-dogies-comprehensive-asicminer-cube-setup-hd-352658
That should get you going. The plug with the jumper tells your power supply to turn on - much better than the old paper clip trick. There are a number of power supplies you can use. I'm using the XFX Pro 550W which is more than sufficient for a single cube. I'm using BFGMiner for the stratum proxy because I also have BE USB devices and so already have BFGMiner running.
That should get you going. The plug with the jumper tells your power supply to turn on - much better than the old paper clip trick. There are a number of power supplies you can use. I'm using the XFX Pro 550W which is more than sufficient for a single cube. I'm using BFGMiner for the stratum proxy because I also have BE USB devices and so already have BFGMiner running.
https://bitcointalk.org/?topic=205369.0
That's about the best you will find !! Good luck hope it helps
That's about the best you will find !! Good luck hope it helps
Ok, so I just got my 30gh/s cube and dont want to mess it up. Having problems finding any write ups in regards to starting this thing up. what all do I need? Power supply, cables.... what is the plug it comes with, with a jumper wire for?
Jump to: