Help needed please. Wallet problem.
My Bulwark 1.3.1.0 wallet worked fine until my PC froze yesterday. Since than when i try to open the wallet the icon shows up in the tool/task bar and that's it.
When i right click on the icon in the tool bar i get some options like send/receive/repair/whatever but no working interface.
Steps so far tried to solve this issue:
- Deleted all Bulwark folders
- Deleted all Bulwark Reg files
- Restart and new Wallet install with new downloaded wallet files.
result: no success
- renamed folders
result: no success
- tried to use a backup i had when updating from 1.3.1 from 1.3.0
result: error message: Failed reading from database. pcoins tip from database is incorrect .....
- used only wallet.dat from back up.
result: no success
Nothing helps. Same issue over and over again. Any ideas, suggestion, advice? whatever?
Thx in advance.
While the wallet is running but unable to open, is it using excessively high amounts of CPU and RAM? I've seen similar things when someone makes hundreds of tiny inputs, which would explain why none of your fixes are working.
Yes, wallet is running but i'am unable to open it, that describes it pretty good. I didn't notice the high amount of CPU and RAM, but maybe that is because i'am on a high end PC with 64GB RAM and latest I7 CPU.
Not sure if i have hundreds of tiny inputs, but yes, they are a lot, staking rewards about daily and about 5-6 rewards from mining and now autoexchange to BWK. So daily about 7 inputs to the wallet.
But than again, what's the fix for it?
I have temporary installed the wallet on a laptop and transfered my wallet.dat file there and it's ok, but of course that's not the solution i'am looking for.....
Well in order to give you a fix I need to figure out what the problem is, yeah?
If you go in to coin control, (To enable it if it isn't already, Settings > Options > Wallet > Enable coin control features) If you have hundreds of tiny little inputs, I would suggest condensing them.
Next, you say its working perfectly fine on another computer while using the same wallet.dat? Does the PC giving you issues have any anti-virus software or firewalls on it? If the answer to either of those is yes, I would suggest whitelisting the BWK wallet, or just stop using them entirely.
And third, now that the wallet.dat is safely working on another PC, I would recommend deleting the Bulwark wallet as well as everything in your appdata folder for Bulwark, and starting over fresh. If that does not fix the issue, then it pretty much confirms that its a AV/Firewall issue.
