While setting up multiple nodes;
Is it important that which output (hash,index) belongs to which address and transaction?
Because it's not written on debug console after the masternode outputs command.
At first I wrote them randomly. But then, wanted to be sure about it, and enabled coin control and manually found each output hash belongs to transactions and then, matched them with the index number manually again.
I hope all work fine, it's been 10 hours and still didn't get any pays, and found a few of them in status "missing" while they were all "enabled" at first.
Is it important that which output (hash,index) belongs to which address and transaction?
Because it's not written on debug console after the masternode outputs command.
At first I wrote them randomly. But then, wanted to be sure about it, and enabled coin control and manually found each output hash belongs to transactions and then, matched them with the index number manually again.
I hope all work fine, it's been 10 hours and still didn't get any pays, and found a few of them in status "missing" while they were all "enabled" at first.
I not sure if it does make a difference but i assume it does. In the guide I did I say to send it to bittrex and send the 10000 to the wallet. Take note of the output address then use masternode output to find out if the end number is a 1 or a 0.
Yes I read it but transaction in bittrex didn't match with outputs, so I was confused and enabled coin control and get transaction hashes from there and matched them one by one.
But now while all nodes work , one of them goes missing always? I dont understand why!?
) 
