Proof of Work ERC20 Token
http://poweth.org/
- No premine or Dev fee!
- 100.000.000 possible maxiumim supply
- Decimal 8
- Block reward: 250 and halved by the time.
- Mining algo: Keccak256
- Difficulty adjustment: Every 1.000 Block!
- Blockchain: Ethereum mainnet
- Token can be stored on spend with any ERC20 compatiable wallet!
- Transactions are fast just like the Ethereum transactions.
- By the time when ETH became PoS, PoWEth still can be mined.
- Etherdelta,Forkdelta exchanges are already available.
- No Pool mining needed, it will be optional when difficulty became higher.
- Spread out in the community and help peoples to join mining and using their tokens.
- Submiting to Exchanges and Coinlisting websites.
- To get started You should have an Ethereum Wallet/Address pre-loaded with some ETH on it as you will need it for gas when solo mining.
- Download MVis Token Miner here. https://github.com/mining-visualizer/MVis-tokenminer/releases
2.
Once extracted, there will be a folder labeled tokenminer and inside of that folder will be a file labeled tokenminer.ini.
Use Notepad or any other simple text editor to open the tokenminer.ini file. Once you've done so, you will need to replace the information inside of it with your own. Make sure you do not delete or remove any of the other information inside the file.
ONLY replace the information in file specified below with your own:
Host=https://mainnet.infura.io/anb94achAHWObifKnoZ7
RPCPort=8545
MinerAcct=0x……………….
AcctPK=……………………
TokenContract=0x1c9be00d799132986edcd2d099b9f28e5757677c
GasPrice=5
MinerAcct is your Ethereum account. (Remember to have some ETH on it.)
AcctPK is the private key of your Ethereum account.
You can adjust GasPrice based on the network requirements.
3.
Opencmd window.
Browse to the location where you extracted MVis Token Miner or drag and drop tokenminer.exe into the cmd window.
Run the following command: tokenminer.exe -S -C -t 1
Note: The above command and steps are for solo mining using you CPU (using 1 CPU thread.) You can adjust amount of threads by changing -t 1 to the number of threads you wish to mine with. If you wish to GPU mine, the steps are the same except when running the command, you would use: tokenminer.exe -S -G