Topic: Antrouter - page 2. (Read 1836 times)

Der würde mir zum spielen auch gefallen, aber hier in der EU einfach viel zu teuer...

Damit meinte ich den kleinen hier
https://bitcointalksearch.org/topic/gekkoscience-compac-bm1384-stickminer-official-support-thread-1173963

hab ihn falsch benannt


Edit: lese grad, dass jemand einen Block gefunden hat mit dem Stick

Damit meinte ich den kleinen hier
https://bitcointalksearch.org/topic/gekkoscience-compac-bm1384-stickminer-official-support-thread-1173963

hab ihn falsch benannt


Edit: lese grad, dass jemand einen Block gefunden hat mit dem Stick

Nein kann er nicht, aber ich benutze zur Zeit genau einen Router den ich per LAN angeschlossen habe und dient einzig fürs WLAN im Wohnzimmer, da kann ich den Bitmain auch gleich verwenden

Was ist der "Grashöpfer"?

I've sold out of R1's, and as promised, I am releasing my customized firmware to the community. Please note that although I refer to this package as custom firmware, it is really just a patch file. If you reset your R1 to factory defaults, you will lose the customizations. In which case, you would just need to re-apply the patch.

Changelog for release 0.95:
- Opened up port 4029 for API access to cgminer-u3 instance
- Max frequency for U3 increased to 250M
- Max fequency for R1 increased to 250M (I have not personally tested freq past 125. Use at your own risk!)


Firmware Enhancements
- U3 zombie handling(Scripted auto-cgminer restarts and R1 reboot if necessary)
- Supports modifying R1 pools from UI, without losing the ability to use Bitmain's solo pool for R1.
- Detailed R1 stats page, including pool statistics
- Supports modifying R1 freq and voltage from UI
- U3 freq selection increased to 250M
- Cgminer-U3 API open for monitoring with 3rd party tools

WARNING: These customizations provide the ability to push your R1 beyond its intended limits. Because of this, it will likely void your warranty with Bitmain. Additionally, I provide this patch with no official support, and take no responsibility for any damage done to your R1 device or its surroundings. Use at your own risk! By downloading and applying this patch, the user is accepting these conditions.

Download Below
R1CGCustomFW_0.95_2015-12-28.tar.gz

Upgrade instructions
To upgrade your firmware, go to "Backup / Flash Firmware" under the "System" tab
- Click on the "Chose File" button to the right of "Restore Backup:" (NOTE: Do not mistake this with the "Chose File" button under Flash new firmware. - This is not a full binary firmware file)
- Choose "R1CGCustomFW_0.95_2015-12-28.tar.gz" from your PC and then click on the "Upload archive" button.

Your antrouter system will reboot and come back up with updated firmware!

Hallo zusammen,

sagt mal was ist denn der Unterschied vom Antrouter Batch 1 zur Batch 3, gabs da technische changes?

https://bitmaintech.com/productDetail.htm?pid=00020160307072415240XwaQIqfF06D3

Und kann man den so einstellen (alternative Firmware) das er nicht Solo auf den Antpool geht sondern auf einen Pool meiner Wahl zb. den Solo Ckpool?

Viele Grüße
Willi