Topic: Bitcointalk account hacked! theymos HELP ME PLEASE! - page 2. (Read 1839 times)

If your miner is not performing normal, then try this first:


1. use original latest firmware from KNC
2. open your terminal and connect with ssh
3. go to advanced tab an set all values to the lowest, everywhere. Volt: "-0.1465" and MHz: "400"
4. then click "apply" and as fast on the mining tab
5. go to the terminal an type: ps
   you will see this line in the upper part of the list:
   "waas -c /config/advanced.conf"
   repeat the ps command after 30 to 40 seconds, when this line is away from the list
   type this command: screen -r  (with ctrl a and d you can exit it)

If you see lines like: "KNC: accepted by FPGA 4 works but only 0 submitted" then quit your miner

6. Go to the system tab and klick on reboot

Let the system time to come up and wait for 2 Minutes when it is up, befor do anything

7. SSH again
8. open web frontend tab: Status and wait until you see the temperature on the right side
9. SSH: check with ps if there is no command waas and also if there is:
    {screen} SCREEN -S cgminer -t cgminer -m -d /usr/bin/cgminer --api-listen -c /config/cgminer.conf
If yes
10. SSH: screen -r   and check the performance
11. now open the tab: Advanced and if nearly all values from the stats are the same, then make little steps
     max. 3 lines up on all values. And now got to step 4.

Also check the HW errors, after every 4-11 step reset the stats inside your cgminer: D then Z then Enter.

If your machine is now performing good, leave the fingers from it, check that you have an backup pool and
during increasing your values be very carefuly.
Do not increase any thing if the Asic Temp is 70'C or DC/DC is bigger then 95'C.

12. If you are finished with your settings, reboot the hole system after one hour and check a last time if you have not
     so much HW-errors, if the temperature is inside an good range and the at last have a look to the performace.

If it helps: 1LQVkJKoZz8uYsnPuYaLU7HE5tGbQaBQFJ
thanks for the tips