Topic: Getting my blade to start hashing - page 2. (Read 2856 times)
Wouldn't I have to put something like this--http://localhost 192.168.0.x-8332 ?
that's exactly what I have in my configuration page.
Same thing just opens and closes.
If you have added --http-port 8332
Then your blade settings should look something like this given your computer that bfgminer is running on has the IP 192.168.0.3 and your router IP 192.168.0.1
Quote
IP
Because you have to run bfgminer in proxy mode for the blade.... you are better off running the usb's on another system. This is bullshit. Rather than giving wrong advice, try not saying anything at all. Well lets see if he gets it working...
I run my BFGMiner in proxy mode too, works for for blades. Ignore the part where stacksmasher says to run the usb on a different system.
What bram says is correct, but I use a .conf file for all my settings. It should get the same end result.
What about brams advice?
Because you have to run bfgminer in proxy mode for the blade.... you are better off running the usb's on another system. This is bullshit. Rather than giving wrong advice, try not saying anything at all.
Create a bat file called something like autominer.bat with with the following command:
bfgminer --http-port 8332 -S erupter:all -o stratum+tcp://stratum.mining.eligius.st:3334 -u YOUR-BITCOIN-ADDRESS -p ANY-PASSWORD save the file. execute the file. It will pickup all the erupters and the blades. Enjoy Because you have to run bfgminer in proxy mode for the blade.... you are better off running the usb's on another system.
I am a complete newb to all this so understand that when you reply I finally got my blades configuration page I would like to add the stratum from my pool into the blades configuration and use BFG Miner to mine because I also have 4 usb block erupters connected using BFG miners now I just need to figure out how to connect my blade.
Jump to:
|
