My new S9B3 is now pointed at KANO.
Unfortunately it popped a breaker in my miner room causing me to have to unplug an S7.
I guess I'll have to put the S9 on a Bitmain 240 instead of the two HP PSU's and move one of the S7's to another room.
My speed on the S9 appears a little below spec and the HW errors on one board are much higher than the other two. Board three is currently much higher in HW errors.
EDIT: I had to pull the plug on the S9 as the temps on board 3 shot through the roof.
Time to move some hardware around.
Uh...kinda hard to run 27 amps of miner on a 20 amp circuit (assuming). I've got a friend here running an S9 on two HP bricks with no problem, but most households (on 120v) are 20A, as are his, so he can't do much else on that breaker. I prefer them. Less expensive, hardy. There have been some pretty informative posts on that board issue. May need to underclock a bit.
They weren't all running on the same circuit.
One S7 on single 240
One S7 on single 120/20 Amp
One S7 with HP PSU's on another 120 15 Amp
The S9 was on a separate 120 with HP PSU's but apparently same circuits as one above.
I've moved some machines around, but still having issues with S9 hardware errors on board 4. Grrrrrrrrrrr The hash rate shot up to the moon on what is called board 4. 163504522.05000 GH/S(RT).
I posted in the hardware section with a screenshot as I don't want to get into too much hardware talk on the pool thread.
But in my defense, I'm pointing all machines to KANO, so it's "kinda" on topic.
