Topic: New Bitmain S9 Firmware Preliminary Testing With Data - page 2. (Read 1057 times)
Any idea what the voltage reads?
Great data, now I need to run the numbers and figure out what SSH port it/does and if I need that 
Um missed the part where he says
Also note that this F/W disables SSH.
?
Is this the S9-xilinx-201905311059 version?
Great data, now I need to run the numbers and figure out what SSH port it/does and if I need that
Great data, now I need to run the numbers and figure out what SSH port it/does and if I need that
Mods, please, oh please do not merge this with the other thread. People need to see the subject line, as this has a day's worth of data (work) on my part 
Firstly! I hope Bitmain continues to release firmware with this kind of adjustability. Also note that this F/W disables SSH, so if that's important to you don't use it.
This is really nice firmware, it gives you a total of 13 settings counting normal.
Below are the preliminary test results, I say preliminary because each setting was run for roughly 30 min. Ideally each one would be run for 24 hrs or so, but I did not want to wait 2 weeks. Power usage and ambient temps were taken from an APC AP8941 "smart" PDU. Other data taken from the miner status page. Run time ~ 30 min each which is three polling cycles on the PDU. The S9 used to test is a February 2018 13.5 Th/S S9 with an APW3++ PSU. Please note the ambient temperature as this room is not temperature controlled and varies as the day heats and cools.
Here's some rough earnings estimates at current difficulty and $0.06 kw/hr pricing, it's sorted by daily net income.
Firstly! I hope Bitmain continues to release firmware with this kind of adjustability. Also note that this F/W disables SSH, so if that's important to you don't use it.
This is really nice firmware, it gives you a total of 13 settings counting normal.
Below are the preliminary test results, I say preliminary because each setting was run for roughly 30 min. Ideally each one would be run for 24 hrs or so, but I did not want to wait 2 weeks. Power usage and ambient temps were taken from an APC AP8941 "smart" PDU. Other data taken from the miner status page. Run time ~ 30 min each which is three polling cycles on the PDU. The S9 used to test is a February 2018 13.5 Th/S S9 with an APW3++ PSU. Please note the ambient temperature as this room is not temperature controlled and varies as the day heats and cools.
Here's some rough earnings estimates at current difficulty and $0.06 kw/hr pricing, it's sorted by daily net income.
Jump to: