Pages:
Author

Topic: [ANN] microCoin 3.0!!!! - page 14. (Read 55147 times)

sr. member
Activity: 369
Merit: 250
October 10, 2014, 05:53:34 PM
#85
As I mentioned earlier, I am staking MRC2 and only receiving about 1 or less MRC due to an update being needed but my question is if the current small payout blocks are going to affect the 90,000 10% blocks or will that be extended to take into account this issue? If not I wish to save my resources until the update has been made.
legendary
Activity: 1274
Merit: 1000
October 08, 2014, 10:45:14 PM
#84
Guys, I'm trying to send my old MRC to alcurex in order to exchange them for MRC2. The problem is I can't generate a deposit address on the exchange. I get this button that says generate new address, I click it then nothing shows up and it tells me to "refresh page to see the address". Obviously when I refresh the page I get back to square one with no deposit address to be found.

WTF... I already tried it on 2 browsers so I don't think that's the issue.

sometime the servers run slow. You need to wait as long as it takes. could be seconds or up to 5 mins. possible more. i doubt it though.

so just click regenerate address and just wait. seriously. wait a few mins with out refreshing or click away.
full member
Activity: 182
Merit: 100
October 08, 2014, 08:03:32 PM
#83
Are we going to be reimbursed for the fee on the 1:1 trade ratio? because it really aint 1 to 1 right now I lost a huge chunk to fees

The fees are given to the alcurex shareholders. You lost huge chunks? How is that possible, everyone has the same low fees....

I have a lot of MRC is how! ha ok im a share holder so perfect
legendary
Activity: 1596
Merit: 1006
October 08, 2014, 06:16:54 PM
#82
@QQ

 look above the qr Qode

Right now it appeared. Before, when I asked, there was no address and the QR code just said "Generate new address" (I scanned it). They did mention it might take "a few minutes" but I didn't imagine it could be this slow.
It seems to take a while to generate a new deposit address in general. Best thing is to click on "generate" and drink a cup of coffe, take a shower... and suddenly it appears Grin.
haha  Cheesy
That's right.
When you click "generate new address", it will make request, but not connect direct to the wallet.
This is because wallets not allow any connection from outside, not even from alcurex siteserver.
This will make some delay, but wallets are full secured.
hero member
Activity: 600
Merit: 500
October 08, 2014, 04:32:22 PM
#81
@QQ

 look above the qr Qode

Right now it appeared. Before, when I asked, there was no address and the QR code just said "Generate new address" (I scanned it). They did mention it might take "a few minutes" but I didn't imagine it could be this slow.
It seems to take a while to generate a new deposit address in general. Best thing is to click on "generate" and drink a cup of coffe, take a shower... and suddenly it appears Grin.
QQ
newbie
Activity: 16
Merit: 0
October 08, 2014, 11:46:26 AM
#80
@QQ

 look above the qr Qode

Right now it appeared. Before, when I asked, there was no address and the QR code just said "Generate new address" (I scanned it). They did mention it might take "a few minutes" but I didn't imagine it could be this slow.
legendary
Activity: 912
Merit: 1000
October 08, 2014, 11:41:23 AM
#79
Are we going to be reimbursed for the fee on the 1:1 trade ratio? because it really aint 1 to 1 right now I lost a huge chunk to fees

The fees are given to the alcurex shareholders. You lost huge chunks? How is that possible, everyone has the same low fees....

There shouldn't be fees on a required conversion stated as 1:1.  Another simple thing that should have been figured out in advance.
legendary
Activity: 1310
Merit: 1000
October 08, 2014, 11:35:00 AM
#78
@QQ

 look above the qr Qode
QQ
newbie
Activity: 16
Merit: 0
October 08, 2014, 11:13:05 AM
#77
Guys, I'm trying to send my old MRC to alcurex in order to exchange them for MRC2. The problem is I can't generate a deposit address on the exchange. I get this button that says generate new address, I click it then nothing shows up and it tells me to "refresh page to see the address". Obviously when I refresh the page I get back to square one with no deposit address to be found.

WTF... I already tried it on 2 browsers so I don't think that's the issue.
sr. member
Activity: 434
Merit: 250
October 08, 2014, 10:49:45 AM
#76
Are we going to be reimbursed for the fee on the 1:1 trade ratio? because it really aint 1 to 1 right now I lost a huge chunk to fees

The fees are given to the alcurex shareholders. You lost huge chunks? How is that possible, everyone has the same low fees....
full member
Activity: 182
Merit: 100
October 07, 2014, 07:01:09 PM
#75
Are we going to be reimbursed for the fee on the 1:1 trade ratio? because it really aint 1 to 1 right now I lost a huge chunk to fees
sr. member
Activity: 369
Merit: 250
October 07, 2014, 06:34:05 AM
#74
Just to be sure, I deleted the MRC folder from the roaming section and used the wallet posted on the from page. ( microCoin version c2.2.0.1: Experimental on debug ). I definitely exchanged old MRC for MRC2.

Should the wallet be listing the currency as MRC2 or still as MRC?

EDIT:

Also, am I not very experienced with PoSing at the moment but I do know by staking I am also able to receive transaction fees as well as payout blocks. I have received a few payments but they are between .5 to 2 MRC. How much per million would someone expect to receive at the current 10% annual rate listed? I have only been able to find a Peercoin PoS calculator but is there one I can fiddle with the settings to apply to MRC and any other coin I wish to PoS?
Currency tigger is still MRC even you use new version.
Yes, there is something with PoS, will be fixed in next version update.
Seems like stake profit is way under 10% annual.

Thank you for the information. Do you have an estimate for when the PoS update will be?
legendary
Activity: 1274
Merit: 1000
October 06, 2014, 11:16:22 PM
#73
communitycoin has some smooth POS. it ran smooth and staked easy. Dont want to bring it down but that coin is dead. Maybe you can look into their code to help improve.
hero member
Activity: 546
Merit: 500
PGP 9CB0902E
October 06, 2014, 03:25:50 PM
#72
Yes, there is something with PoS, will be fixed in next version update.

Do you having *any* ETA on this update?
My wallet has only made one payment since the change to MRC2.

I tried deleting everything in the roaming folder and restarting,
uninstalling and reeinstalling, but no transtactions seem to come up.
newbie
Activity: 5
Merit: 0
October 06, 2014, 02:58:55 PM
#71
Getting MRC on mintpal on crpytsy should be a big priority not to mention the added feature of anonymity that makes verticoin so popular.
hero member
Activity: 938
Merit: 1000
October 06, 2014, 09:15:06 AM
#70
Thanks halibit for the new wallet. It could attract a lot of new investors since the client opens much faster and the network too.
Do you have the future plan for MRC in mind ?
legendary
Activity: 1596
Merit: 1006
October 06, 2014, 09:02:01 AM
#69
Just to be sure, I deleted the MRC folder from the roaming section and used the wallet posted on the from page. ( microCoin version c2.2.0.1: Experimental on debug ). I definitely exchanged old MRC for MRC2.

Should the wallet be listing the currency as MRC2 or still as MRC?

EDIT:

Also, am I not very experienced with PoSing at the moment but I do know by staking I am also able to receive transaction fees as well as payout blocks. I have received a few payments but they are between .5 to 2 MRC. How much per million would someone expect to receive at the current 10% annual rate listed? I have only been able to find a Peercoin PoS calculator but is there one I can fiddle with the settings to apply to MRC and any other coin I wish to PoS?
Currency tigger is still MRC even you use new version.
Yes, there is something with PoS, will be fixed in next version update.
Seems like stake profit is way under 10% annual.
sr. member
Activity: 369
Merit: 250
October 06, 2014, 12:42:13 AM
#68
Just to be sure, I deleted the MRC folder from the roaming section and used the wallet posted on the from page. ( microCoin version c2.2.0.1: Experimental on debug ). I definitely exchanged old MRC for MRC2.

Should the wallet be listing the currency as MRC2 or still as MRC?

EDIT:

Also, am I not very experienced with PoSing at the moment but I do know by staking I am also able to receive transaction fees as well as payout blocks. I have received a few payments but they are between .5 to 2 MRC. How much per million would someone expect to receive at the current 10% annual rate listed? I have only been able to find a Peercoin PoS calculator but is there one I can fiddle with the settings to apply to MRC and any other coin I wish to PoS?
legendary
Activity: 1596
Merit: 1006
October 05, 2014, 08:47:34 AM
#67
how to convert old MRC to MRC2 after send to alcurex the amount = 1:1 or no?
just sell your MRC in MRC2 market with price 1.
full member
Activity: 235
Merit: 100
October 05, 2014, 05:13:27 AM
#66
how to convert old MRC to MRC2 after send to alcurex the amount = 1:1 or no?
Pages:
Jump to: