So i tried your MultiPoolMiner.
Hmm, been mining Monacoin over the night and my hash rates were 68MH/s with a single 1080ti. I only used one card to test your script.
Yet the pool only reports 35MH/s. Care to share where the rest went to. Donation is switched off. Not that I wouldn't donate, but for testing purposes it was set to off. Please explain to me why I only see half the hash rates on the pool. Your script chose Palgins CCminer, but my other rigs use Nahashi and the hash rates are normal.
Also, even though I entered my username in the start bat file, there are still over 30 files that contain your workernames in them and they are being used when bench-marked.
MPM actually has Nanashi, two versions actually. You can disable Palgin by going into the miners folder and select the Palgin ccminer and right click and select edit, and place a # in front of Lyra2v2. You can then do the same to enable both Nanashi's, just remove the #. Hmm, been mining Monacoin over the night and my hash rates were 68MH/s with a single 1080ti. I only used one card to test your script.
Yet the pool only reports 35MH/s. Care to share where the rest went to. Donation is switched off. Not that I wouldn't donate, but for testing purposes it was set to off. Please explain to me why I only see half the hash rates on the pool. Your script chose Palgins CCminer, but my other rigs use Nahashi and the hash rates are normal.
Also, even though I entered my username in the start bat file, there are still over 30 files that contain your workernames in them and they are being used when bench-marked.
BUT the actual numbers when I go to my balances page and watch the progress/increase, are not showing that to be accurate at all. More like 2+$. How would I figure out why this is happening and what might I do to actually achieve these numbers showing on my miners?