Topic: [ANN][TRICK] TrickyCoin : x11 : NEW QT5 WALLET WITH IRC CHAT - page 9. (Read 26612 times)

Everything seems fixed now, I am staking properly and just transfered my coins from Yo-Bit with no problem.

Ok now we wait for weight

and the wait is over 3 secs later.

I am staking

Fully synced up, and just removed reservebalance and as of this moment we are MOVING! BTW: Good fucking job!

A little closer. I have sync'd my wallet and successfully transferred some funds. Let me test some incoming and I'll share what I did.
I suspect we had a chain fork. There is a solo miner out there. It messed up staking badly.

Gimme a sec...

OK bad new is this fix shuts off staking. But at least wallet will work while I continue to figure it out

%appdata%/trickycoin
Remove all except your conf and wallet.dat
If you remove your wallet.dat all your coins are lost. SO BACK IT UP FIRST!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Change conf to this

rpcallowip=127.0.0.1
rpcuser=youruser
rpcpassword=yourpass
addnode=5.231.235.32
addnode=trick.coin-miners.info
addnode=https://trick.minerpools.com:
addnode=http://rapture1.cloudapp.net:8080/
addnode=http://hashgoal.com/pool/TRIC/
addnode=node.coin-miners.com
addnode=node.trickycoin.com
rpcport=13413
port=13414
reservebalance=1000000
dns=1
dnsseed=1
listen=1

of course you can play with those settings. The reservebalance part stops staking

I am receiving my mined coins from pool now and I can transfer both directions


More to follow......I apologize guys.


UPDATE. I did the following and allowed peers.dat to fully update. Wait about 5 mins
Then i REMOVED reservebalance=1000000 and restarted wallet

I AM NOW STAKING AND HAVE 2 CONNECTIONS AND AM STILL RECEIVING COINS ( I DID NOT LOSE MY WEIGHT)
WE WONT SEE NETWORK WEIGHT FOR A WHILE BUT I THINK WE ARE CLOSER

SOMEONE ELSE TRY THIS PLEASE

im just turning off my wallet, but i think this thing occurred when the first pos block was created, it paid out all interests on each block transaction deposited into wallet, rather than put them together and send out in just 1 payment, hope you get it fixed soon, im sure you will.

Good to hear your trying to get it working, its not to FUBAR if the pools wallets and exchange wallets are synced, could the problem be linked to just the windows wallets?

I am tracking down what the heck is happening.
I may be offline in forums but I am steady looking for issue.

For now I advise stop transferring to wallet from pools.

Any programmers wanna help PM me

Not sure, but try to add to your current config this:

Any update? Coin-miners pool is doing just fine, I can transfer straight to Yobit without problem but I would much rather be able to put it in wallet to mature. The problem being is that I have seen my wallet move about 10% of the way to syncing since POS kicked in. It will connect and move 3 blocks or so and then disconnect for about 15 min and repeat.

it payed me out loads of tiny little payments at once then it stopped, im guessing these need to be compiled together before the stake payment

here as well

and connections are zero lol

STAKING HAS BEGUN

Nethash just took a huge jump, looks like this coin is gaining some attention. Looks like POS just started as well.

ok changed it, 5 active connections, wonderful

Yes works, i have 5 active connections now, thanks dev

My address pool will not work , you need to add this one addnode=node.coin-miners.info

2 is fine but you can always add all the pools along with my node

addnode=5.231.235.32
addnode=trick.coin-miners.info
addnode=https://trick.minerpools.com:
addnode=http://rapture1.cloudapp.net:8080/
addnode=http://hashgoal.com/pool/TRIC/


Restart wallet after making that change. Might take a minute or so to get updated

i have 2 active connections in my wallet,  is there any more nodes to add to the downloaded .conf on op ?

TRICK up 406% on YoBit

 https://yobit.net/en/trade/TRICK/BTC