Topic: asicminer v2 blade issue - page 2. (Read 1206 times)
What's it read out after running for at least half an hour?
hi i am wondering if any of you guys can help me out with my asic miner v2 i have a dead lane and it is really slow, 70 mhash/s can't
I have checked the power supply, it is putting a 11.995v out is this a little too low for the unit?
Here is a screenshot
I have checked the power supply, it is putting a 11.995v out is this a little too low for the unit?
Here is a screenshot
Good luck finding help here.
Right off the bat I'm gonna always say "cooling". With all my blade issues it was a cooling problem, except whatever I'm dealing with presently. However, I notice you have some "x" characters in with your "0" string on the web interface, which indicates an error. I'd point more fans at it and see if that helps, but you might need to do a hardware reset to clear those errors, not really sure...
hi i am wondering if any of you guys can help me out with my asic miner v2 i have a dead lane and it is really slow, 70 mhash/s can't
I have checked the power supply, it is putting a 11.995v out is this a little too low for the unit?
Here is a screenshot
http://i146.photobucket.com/albums/r262/ertgunner/Untitled_zps193ab17f.png
I have checked the power supply, it is putting a 11.995v out is this a little too low for the unit?
Here is a screenshot
http://i146.photobucket.com/albums/r262/ertgunner/Untitled_zps193ab17f.png
Jump to: