Wait, so the X-1 doesn't come with a power cord like the one pictured here?
What is that power cord called, and how would the LCD plug into the main controller board?
Topic: BA X-1 Unboxing - page 6. (Read 6723 times)
Glad you found a power cord. It will take 240- Saw them running at their office off China 220 and we tested at our facility on 208.
The first of my X-1 units arrived today. I have only gone as far as pulling it out of the box but I thought everyone might like to see some photos.
The obvious item to note is the absence of the LCD. It is supposed to be on the way when they are finished.
Also the "mickey mouse" style PSU plug. I'm not sure if it will take 240 power. I need to figure that out before I plug it in at the "data center" - aka my basement.
*** The unit did not come with a power cord ***
Front:
Rear:
Typical Running configuration:
Management GUI example:
Miner GUI example:
General Set up instructions:
X-1 FAQ:
Q: What kind of power cord do I need?
A: A standard "mickey mouse" cord. The technical name is IEC C5.
Q: How loud is the X-1?
A: The device makes no sound itself. There is very slight wind rustle this isn't audible 4 or 5 feet from the unit.
Q: How much power does the X-1 consume?
A:1200Mhz - 120-130gh - ~115-120w
1100Mhz - 112 - 118GH - ~107W
1000Mhz - 98 - 109GH - ~98W
Q: Does the X-1 come with an Ethernet cable?
A: No
The obvious item to note is the absence of the LCD. It is supposed to be on the way when they are finished.
Also the "mickey mouse" style PSU plug. I'm not sure if it will take 240 power. I need to figure that out before I plug it in at the "data center" - aka my basement.
*** The unit did not come with a power cord ***
Front:
Rear:
Typical Running configuration:
Management GUI example:
Miner GUI example:
General Set up instructions:
- Attach the Ethernet port to a network that is handing out DHCP addresses. Attach the power cord (that might or might not be included to 120, 208, or 240 volt power.
- The Management server should pick up a DHCP address.
- Navigate to http://DHCP_IP_Address/lcd
- You should be presented with the Miner GUI login screen. Login with user / blackarrow
- Navigate to the IP settings screen and configure a static IP that is available on your network.
- Navigate to the pool setting screen and input your pool configuration.
- Validate that the settings have been saved and pull the power cord to reset the device.
- Navigate to http://DHCP_IP_Address/ and login with user / blackarrow. Select the miner in the top left of the GUI. This will display the mining statistics for the integrated miner. You should have an obvious green flashing LED inside of the unit if the miner connects and is hashing.
X-1 FAQ:
Q: What kind of power cord do I need?
A: A standard "mickey mouse" cord. The technical name is IEC C5.
Q: How loud is the X-1?
A: The device makes no sound itself. There is very slight wind rustle this isn't audible 4 or 5 feet from the unit.
Q: How much power does the X-1 consume?
A:1200Mhz - 120-130gh - ~115-120w
1100Mhz - 112 - 118GH - ~107W
1000Mhz - 98 - 109GH - ~98W
Q: Does the X-1 come with an Ethernet cable?
A: No
Jump to: