I'm getting one D3 in Nov. So were you able to change the fan speed to reduce the noise?
Actually just underclocked my oct batch (19.3) to keep running below 70. Running currently at 14k mh/s. 0HW so far.
Seems like at default settings it was running up too 80 and kept resetting itself for some reason after an hour or so.
Seems like at default settings it was running up too 80 and kept resetting itself for some reason after an hour or so.
I am totally not worried about the noise tbh. But imo they are louder then l3+ and it goes to 100% fan speed every 10 minutes for 10 seconds for no reason, so they can get quite noisey. The temps are what I am worried about running at 19.3.
I can get it stable at 70c on 19.3k mh/s with my warehouse open in back and front with room temp of 13, But its just not an option for me.
Why don't you set the fan speed on a fixed percentage? I use mine on 90-97% speed and besides the less stress you put on the motors it also cools the chips down by 5-10°C (the temp at least was lowered almost 10°C on my L3+)
If they are in a warehouse anyway you dont need to worry about the noise at least
I do have a warehouse, but there are people sleeping above it. I was happy at first, they have a big gate surrounding my warehouse including cameras, always people near it, but at this point, my next location will be on some industrial zone so I dont have to worry about complaints. Anyway, I tried putting it on 90% the difference was very small, so maybe I have to seriously look into get the hot air straight out using tubes or whatever. At this point I rather trade it for an L3+.
