Topic: [Guide] Notlist3d's Dragon 1.5 Guide and Info (Picture Heavy) - page 2. (Read 2852 times)

Q: Where can I get a copy of firmware:
A: https://www.dropbox.com/s/so2wrtqbqd6jzzs/Dragon1.5boot.rar?dl=0

Q: My hash seems to be low
A: Try different difficulty's I have had good luck with 512 and 1024, but it might very depending on your location and pool used.

Q: Can power usage be higher then spec?
A: Yes on mine it can at least after testing I have got up to 1130-1150 wats on high side.

0) General information + Hardware Needed
1) Unpacking
2) The Miner
3) Install
4) How to order



0) General Information + Hardware Needed
This miner is a new version of the Dragon 1T (A1 1T) miner produced by lketc.  Their old miner has been tested over time, and you will feel familiar with interface if you have used a Dragon before.  With this new Dragon 1.5T it is made to be more energy efficient with power usage of around 1070 watts .

Hardware needed in addition to Dragon 1.5T miner:
•   Computer to set up the Dragon 1.5T configuration.
•   Network cable to connect to router/hub, and power cable(It comes with a EU plug, and a small network cable)


1) Unpacking
You will notice the weight once you pick up the box.  With having 6 blades with nice heat sinks it help’s with cooling down the miner but explains shipping cost. Taking the miner out of the box you will see a familiar Styrofoam.  With this packing it keeps the miner in the center of the box helping make transport safe, and where miner has a cushion of air to protect from puncture on sides. Below is pictures of the unpacking:  



2) The Miner
Dragon 1.5T General Information:
Hash rate on pool side: ≥1500G
Power consumption: 1070 watt  *Actual watt's seems to be closer to 1150*
Size: 480*176*380 mm
Gross weight: 22 Kg
Noise: less than 52 DB
Chip quantity: 60 PCS 28nm ASIC
Package includes: 1500G Miner*1 PWM Cable *1 UTP Cable *

Below are images to showcase the miner.  Some show comparison to showcase it’s size beside a Dragon 1T.






3) Install
A)This miner is built on the Dragon 1T software.  It will feel very similar to setup.  No power supply tricks needed, just flip the switch after plugging in power cable and network cable!

B)After the miner has booted up you will need to go to the IP written on the miner’s front side. Its 192.168.1.XXXX

C)Below is shown a picture of my miner set up.  Yours can be different on numbers but first you need to have IP, Subnet Mask, Gateway IP, and DNS.  After putting your settings in it you are able to confirm it by pressing set network:

D)After setting the IP address and network settings you are ready to add your favorite pool.  With miner stopped you will be able to edit pool settings.  After you enter your miner pool settings click on the start button, then OK.:

E) After you set the network and pool settings, you should be hashing away! Below is mine hashing away a little above 1.5 after a few hours so far.  I will continue to test over next few days.

4) How to order


Go the website directly: http://www.easy2mine.com/
Or the main Easy2Mine group buy thread: https://bitcointalksearch.org/topic/wwweasy2minecom-340-the-group-buy-of-antminer-s5psu-included-514758