Topic: The Blocks Factory - Multicoin pool - page 26. (Read 198348 times)

Hello! what better to specify the difficulty for DGB SHA256 using S7 and S9?
Ктo чтo пpoбoвaл? нигдe нe мoгy нaйти oтвeт...

I recently tried to withdraw PXC from the pool to my PXC-wallet(PZdCMdKkLaw4jMk1NyYrU89W73M4GaKPV9), the coins are gone but the transfer ID is 0? Where are my coins now?

http://explorer.phoenixcoin.org/tx/0

Site-Admin please contact me urgently.



raz0r

Iguees the groetstl is dead? no response here or anywhere...

Same issue mate, pin stopped working. No support, very sus!

Can admin please respond to my requests for support? My pin is no longer working on the pool and i'm unable to withdraw my earnings.

Why do i have less than half the hash of last week? Performance has dropped more than half

Just to report that I am mining on TBF groestl pool for three days without any problems. Everything is working OK now. Total pool hashrate is around 70 GH/s ATM.

Is there a way to reset the PIN?
It doesn't work 

Hi all,

I just came back from vacation to see that I can mine but nothing is showing progress on the website ( https://dgb-groestl.theblocksfactory.com)

Please advice ?! Im so newbie

So I need to change to another pool? and how do i do this?

Thx
C

My wild guess is that your miners hashrate is so low that even to the smallest static difficulty (which is 0.016 like Lucazane said literally 3 posts above) causes your sharerate go way more down than what it was with previous minimum sharediff, 0.008. With my secondary card, GTX 960, this is the case and now I have to mine with it at Skein-pools, since I get about half of its miners reported hashrate if using Groestl with the current minimum sharediff.

As numbers, it's miner reports about 30-31MH/s, with earlier static diff (0.010) pool showed most usually 23-30MH/s and nowadays with 0.016 or higher an average of 16MH/s.

Other possibility is that you haven't updated your miner configuration of the static difficulty if you're using it, since as example on my case - I've got pretty unstable hashrates on pool as well if using automated vardiff since it seems to put pretty aggressively the diff so high that the actual results suffer pretty heavily at overall.

On my 1080Ti I've used fixed diff of 0.05, and the hashrate on pool is shown within 5% of difference at max compared to miners reported hashrate so it has worked on me.

But on the other hand; reading by what Lucazane wrote, the minimum sharediff had to be raised due to way too high constraint on server (resulting to the hard crash most likely), I totally understand his point. Too small miners and bigger miners with way too low fixed sharediff easily congest the server to it's knees instead of helping efficiently to find those blocks.

YeeS me I have the same problem!!!! Some one has solve it?

What going on with Groestl? Huh I'm there for long time and now the hash rate from the console doesn't match with my pool hash power. What you did these past days!?!?

I came back, Only 1/3 of my 1080ti's

I think u need to pay more attention on your mining pool.
Many Peoples complain about the admin's less-connection's

I will see how it works. I will get only 9~10G hash on TBF.

For thoses who didn't had the opporunity to switch pool during the outage of the groestl pool, please send me a PM.

I have a set the minimum difficulty(0.016) higher to lower the constraint on the database.

I have also set the fee at 0 and added the extra reward for the block finder.

The last week definitely had some very low payout days on DGB-Skein.

Decided to switch to MiningPoolHub and immediately seeing results like the best days at TBF. Lower fees as well.

Yes, me the same ... Why is this happening??? Half of the hash rate...

Thanks so much Lucazane.
I have now two questions about the pool.

1. Is possible to know how much share was sent per worker? I would like to know how much each worker are sending (because 3 workers is not in my house).
2. Is there a problem with Hashrate? In website pool is with half hashrate of my mine report. 

I was mining about 29 hours.ended and changed pools something around one hour before posting in this thread so maybe 30 but closer to 29. I wonder how are those untracked shares are going to be credited? by the average od last day before database crash?  because right now it looks like pool simply took them.

Hi Lucazane,

I was mining almost the whole time during your database outage...  About how long until we're credited for the shares we submitted during that time?

What's going on with Groestl? I'm there for long time and now the hash rate from the console doesn't match with my pool hash power. What you did these past days!?!?