my masternode works only for like 2 hours.
after that it doenst work anymore. After this i delete my mn and create a new one. i do this every two hours.
does anyone know what the problem could be?
In your conf file, do you have the line staking=0? If you do not have normal staking turned off, when a normal stake hits, it will likely use the input that is your masternode collateral, and split it into two inputs. When it does this, you no longer have one input that is exactly 13342 coins.
Yes staking=0 at config file.The reason i say my masternode isn't working anymore is because i dont see myself at node count. When it was working i saw myself ofcourse.
Funny thing is when mn work i see myself at node count but i'm always 0,00 Active. But i do get mn rewards.
After 2 hours i dont see myself at nodecount, try to restart my mn and i get a pop-up whitch says: could not allocate vin for collateraladress.
just likt that
I think others are experiencing this - I tried asking the question earlier but no response. It's strange, sometime one mn will work for 12+ hours and other times it shuts down within an hour or two. I have noticed that you will move down the ranks in the mn's list - try this, instead of making a new mn and closing the wallet - when you don't see yourself in the list anymore go to My Cryptbit Nodes, choose your mn and click Start.
You should see a message saying it was started. If you're in front of your comp you'll notice when your not staking because it's a pretty steady stream - basically just keep an eye in that list and just start your mn again. It's a bit of a pain but worth the easy
BTC Let me know how you get along.
I restart my MN when i'm out of the list, i dont create a new one. I can restart my MN maybe 2 or 3 times, by the forth time i want to restart my MN it says: could not allocate vin for collateraladress
after this message i create a new one.
I have the same problem. Checking the debug.log, it's full of messages like this:
ProcessMessages(dsee, 253 bytes) : Exception 'CDataStream::read() : end of data: iostream error' caught, normally caused by a message being shorter than its stated length
ProcessMessage(dsee, 253 bytes) FAILED
CActiveMasternode::ManageStatus() - Checking inbound connection to
my_IP_address:9999'
CActiveMasternode::ManageStatus() - not capable: Could not connect to
my_IP_address:9999
Any ideas?