Topic: [ANN] Technobit HEX8A1 -240 GHs Coincraft A1 board- Finished production - page 2. (Read 72437 times)

Soory to say but at time i have the self problem, with no hash!?

At the evening i will test with a second power supply

cgminer version 4.4.2 - Started: [2014-12-06 11:59:35]
--------------------------------------------------------------------------------
 (5s):0.000 (1m):168.9M (5m):3.229G (15m):2.438G (avg):3.443Gh/s
 A:784  R:0  HW:0  WU:49.1/m
 Connected to miner-control.de diff 16 with stratum as user
 Block: d970747b...  Diff:1.08M  Started: [12:14:40]  Best share: 863
--------------------------------------------------------------------------------
 USB management Pool management Settings Display options Quit
 4: HEX8 4  : 220  850/ 800mV  |  0.000 /  0.000h/s WU:  0.0/m
--------------------------------------------------------------------------------
 [2014-12-06 12:05:21] HEX8 0 failure, disabling!
 [2014-12-06 12:06:42] HEX8 1 failure, disabling!
 [2014-12-06 12:06:57] HEX8 2 failure, disabling!
 [2014-12-06 12:09:33] HEX8 3 failure, disabling!

cgminer version 4.4.2 - Started: [2014-11-29 23:26:11]
--------------------------------------------------------------------------------
 (5s):0.000 (1m):0.000 (5m):0.000 (15m):0.000 (avg):0.000h/s
 A:0  R:0  HW:0  WU:0.0/m
 Connected to miner-control.de diff 16 with stratum as user
 Block: d3fc8303...  Diff:1.19M  Started: [23:27:36]  Best share: 0
--------------------------------------------------------------------------------
 SB management [P]ool management Settings Display options Quit
 0: HEX8 0  : 220  850/ 800mV  |  0.000 /  0.000h/s WU:0.0/m
--------------------------------------------------------------------------------
 [2014-11-29 23:26:01] Started cgminer 4.4.2
 [2014-11-29 23:26:01] Loaded configuration file /home/pi/cgminerHEX.conf
 [2014-11-29 23:26:10] Probing for an alive pool
 [2014-11-29 23:26:10] Pool 0 difficulty changed to 16
 [2014-11-29 23:26:11] Pool 1 difficulty changed to 16
 [2014-11-29 23:26:11] Network diff set to 1.2M
 [2014-11-29 23:26:16] API running in IP access mode on port 4029 (13)

THX at all,

at time the miner runs perfect on this:

"hexminer8-chip-mask" : "255",
"hexminer8-voltage"  : "860",
"hexminer8-options" : "8:230",

so a other question to make the miner quieter

Have the HEX temp sensors or is the air flow @ 5 or 7 V enough around 220GH/s?

I think 7V is enough and better than 5V!?

regards

THX it's s so right:


and i only install cgminer with these commands:

./configure --enable-hexminer8

use 230/860 it should do 230 GHS roughly
if not there might be a dead chip or not enough power

"hexminer8-set-diff-to-one" : "0",
"hexminer8-chip-mask" : "230",
"hexminer8-voltage"  : "860",
"hexminer8-options" : "8:230",
"set_default_to_8" : true

Hello guys,

thanks for your help, i have solved my problem

I have run 2 Cgminer instances at the Pi and so runs the miners all at one Pi 

I hope you can still help with the settings myself, i would run my HEX8A1 miner for tests at 200 GH/s, what settings i need?

At the moment the miner runs at ~ 160 GH/s?


THX for your help

"hexminer8-set-diff-to-one" : "0",
"hexminer8-chip-mask" : "240",
"hexminer8-voltage"  : "900",
"hexminer8-options" : "8:240",
"set_default_to_8" : true

Yes you should build cgminer with our patch and the options you need for Rpi and run it

make[2]: Entering directory `/usr/src/cgminer'
  CC     cgminer-cgminer.o
  CC     cgminer-util.o
  CC     cgminer-sha2.o
  CC     cgminer-api.o
  CC     cgminer-logging.o
  CC     cgminer-klist.o
  CC     cgminer-noncedup.o
  CC     cgminer-fpgautils.o
  CC     cgminer-usbutils.o
  CC     cgminer-driver-bitfury.o
  CC     cgminer-driver-icarus.o
  CC     cgminer-driver-hexminer8.o
  CCLD   cgminer
cgminer-driver-bitfury.o: In function `nfu_close':
/usr/src/cgminer/driver-bitfury.c:380: undefined reference to `mcp2210_spi_cancel'
/usr/src/cgminer/driver-bitfury.c:387: undefined reference to `mcp2210_set_gpio_settings'
cgminer-driver-bitfury.o: In function `bxm_shutdown':
/usr/src/cgminer/driver-bitfury.c:593: undefined reference to `spi_clear_buf'
/usr/src/cgminer/driver-bitfury.c:594: undefined reference to `spi_add_break'
/usr/src/cgminer/driver-bitfury.c:595: undefined reference to `spi_add_fasync'
/usr/src/cgminer/driver-bitfury.c:596: undefined reference to `spi_config_reg'
cgminer-driver-bitfury.o: In function `nfu_detect_one':
/usr/src/cgminer/driver-bitfury.c:449: undefined reference to `mcp2210_get_gpio_settings'
/usr/src/cgminer/driver-bitfury.c:468: undefined reference to `mcp2210_set_gpio_settings'
/usr/src/cgminer/driver-bitfury.c:492: undefined reference to `mcp2210_spi_cancel'
cgminer-driver-bitfury.o: In function `bxm_reinit':
/usr/src/cgminer/driver-bitfury.c:754: undefined reference to `spi_clear_buf'
/usr/src/cgminer/driver-bitfury.c:755: undefined reference to `spi_add_break'
/usr/src/cgminer/driver-bitfury.c:756: undefined reference to `spi_add_fasync'
/usr/src/cgminer/driver-bitfury.c:757: undefined reference to `spi_set_freq'
/usr/src/cgminer/driver-bitfury.c:758: undefined reference to `spi_send_conf'
/usr/src/cgminer/driver-bitfury.c:759: undefined reference to `spi_send_init'
cgminer-driver-bitfury.o: In function `bxm_detect_one':
/usr/src/cgminer/driver-bitfury.c:806: undefined reference to `spi_clear_buf'
cgminer-driver-bitfury.o: In function `nfu_detect_one':
/usr/src/cgminer/driver-bitfury.c:474: undefined reference to `mcp2210_get_gpio_pindirs'
/usr/src/cgminer/driver-bitfury.c:479: undefined reference to `mcp2210_get_gpio_pinvals'
/usr/src/cgminer/driver-bitfury.c:484: undefined reference to `mcp2210_get_gpio_pindes'
cgminer-driver-bitfury.o: In function `bf1_getinfo':
/usr/src/cgminer/driver-bitfury.c:156: undefined reference to `mcp_spi_txrx'
/usr/src/cgminer/driver-bitfury.c:156: undefined reference to `ftdi_spi_txrx'
cgminer-driver-bitfury.o: In function `nfu_detect_one':
/usr/src/cgminer/driver-bitfury.c:494: undefined reference to `mcp2210_get_spi_transfer_settings'
cgminer-driver-bitfury.o: In function `nfu_set_spi_settings':
/usr/src/cgminer/driver-bitfury.c:414: undefined reference to `mcp2210_set_spi_transfer_settings'
cgminer-driver-bitfury.o: In function `nfu_detect_one':
/usr/src/cgminer/driver-bitfury.c:507: undefined reference to `mcp2210_spi_transfer'
/usr/src/cgminer/driver-bitfury.c:511: undefined reference to `mcp2210_get_gpio_pinval'
cgminer-driver-bitfury.o: In function `nfu_set_spi_settings':
/usr/src/cgminer/driver-bitfury.c:414: undefined reference to `mcp2210_set_spi_transfer_settings'
cgminer-driver-bitfury.o: In function `nfu_detect_one':
/usr/src/cgminer/driver-bitfury.c:522: undefined reference to `mcp2210_spi_transfer'
/usr/src/cgminer/driver-bitfury.c:526: undefined reference to `mcp2210_get_gpio_pinval'
cgminer-driver-bitfury.o: In function `nfu_set_spi_settings':
/usr/src/cgminer/driver-bitfury.c:414: undefined reference to `mcp2210_set_spi_transfer_settings'
cgminer-driver-bitfury.o: In function `nfu_detect_one':
/usr/src/cgminer/driver-bitfury.c:537: undefined reference to `mcp2210_spi_transfer'
/usr/src/cgminer/driver-bitfury.c:539: undefined reference to `mcp2210_get_gpio_pinval'
cgminer-driver-bitfury.o: In function `nfu_reinit':
/usr/src/cgminer/driver-bitfury.c:396: undefined reference to `spi_clear_buf'
/usr/src/cgminer/driver-bitfury.c:397: undefined reference to `spi_add_break'
/usr/src/cgminer/driver-bitfury.c:398: undefined reference to `spi_add_fasync'
/usr/src/cgminer/driver-bitfury.c:399: undefined reference to `spi_set_freq'
/usr/src/cgminer/driver-bitfury.c:400: undefined reference to `spi_send_conf'
/usr/src/cgminer/driver-bitfury.c:401: undefined reference to `spi_send_init'
/usr/src/cgminer/driver-bitfury.c:402: undefined reference to `spi_reset'
cgminer-driver-bitfury.o: In function `nfu_detect_one':
/usr/src/cgminer/driver-bitfury.c:555: undefined reference to `spi_clear_buf'
cgminer-driver-bitfury.o: In function `bitfury_check_work':
/usr/src/cgminer/driver-bitfury.c:1350: undefined reference to `libbitfury_sendHashData'
cgminer-driver-bitfury.o: In function `bf1_scan':
/usr/src/cgminer/driver-bitfury.c:1262: undefined reference to `decnonce'
/usr/src/cgminer/driver-bitfury.c:1266: undefined reference to `bitfury_checkresults'
cgminer-driver-bitfury.o: In function `bitfury_check_work':
/usr/src/cgminer/driver-bitfury.c:1344: undefined reference to `bitfury_work_to_payload'
collect2: ld returned 1 exit status
make[2]: *** [cgminer] Error 1
make[2]: Leaving directory `/usr/src/cgminer'
make[1]: *** [all-recursive] Error 1
make[1]: Leaving directory `/usr/src/cgminer'
make: *** [all] Error 2

Ok, thanks i will test it after work with these options:


regards

Yes you should build cgminer with our patch and the options you need for Rpi and run it

cd /usr/src

git clone http://ck.kolivas.org/apps/cgminer/4.4/cgminer-4.4.2.tar.bz2

tar xvf cgminer-4.4.2.tar.bz2

cd cgminer-4.4.2

wget -U 'Mozilla/5.0 (X11; U; Linux i686; en-US; rv:1.8.1.6) Gecko/20070802 SeaMonkey/1.1.4' http://sven-goessling.de/wp-content/uploads/2014/09/rev_45dbbb4cac091e41b0123fd211b6293436921681.patch

git checkout 45dbbb4cac091e41b0123fd211b6293436921681

patch < rev_45dbbb4cac091e41b0123fd211b6293436921681.patch

./autogen.sh --enable-icarus --enable-bitfury --enable-hexminer8

sudo make

Hello THX for your answer,

you think so it's OK?


Is it even possible to use the HEX8A1 with other USB Miner(Bitfury BFx2 and Antminer U2) on the same USB HUB?

regards