v2.04 beta :: 22/12 :: test versionDownload:https://mega.nz/#!ulYlTB4D!nEymzPvujO17EXa95q9_oRHAQOxZUZvxu_bulZ8_wUAChanges 22/12:- reboots the D3 on high temperatures (> 85 deg PCB temp). This feature will save your unit in case your fans will fail.
- improved auto tune algorithm stability
- Increased the chip starting frequency of the autotune algorithm for higher voltages.
Changes 14/12:- fixed auto recover from xxxx
- cleaned up kernel logging
- a bit more aggressive tuning
- tunes down faster now when too many HW errors are detected
Changes 13/12:- Totally rewritten code base, based from latest available bitmain / cgminer sources
- ASIC's now automatically recovers from xxxxx errors without restarting (The auto reboot options are still in there in case it doesn't succeed)
- blazing fast mining status overview in the webinterface
- as requested: the dev mining starts later now (after 5 minutes)
- as requested: dev pools status is now visible in the miner status
Important:
The autotune feature is not completely finished and the startup is a bit slow now.. Therefore I need your help. So what do you need to do:
set your advanced settings the same as displayed bellow
let it run for at least 20 minutes
PM your (complete) kernel log
By doing so I can get to a conclusion what the starting frequency of the auto tune algorithm should be.
In case you want to help more: increase the voltage a bit and do the steps above again as it will give some more information
Thank you!
why 
