Well, as I start this reply it's 1:23pm.
I just OC'd all four of my S3's to 237.5, I have a dentist appointment at three. So after I hit the post button. I'm gonna do a single refresh on all four to see web stats. After that I'll let everything be til probably around 4pm when I get back. If everything looks good, I'll leave them all on 237.5 for 24hrs.
If after that, everything still looks good. Then about this time tomorrow or so I will take the proverbial plunge and try 250 on one of them for 24hrs. If that holds good, then I'll set the second at 250 and let run 24hrs, so on and so forth til I t all four on 250 if I'm lucky.
Between 237.5 & 250, is there any other freqs, I think I saw someone say 240 or something a few pages back.
Ok, so back from the dentist, checked on the four S3's and no x's but I did however notice something weird and maybe it will wind up between now and tomorrow. Anyway, below are as of this post... Elapsed Time, Gh/s(5s) & Gh/s(avg) as well as the HW & the Diff a & r figures.I just OC'd all four of my S3's to 237.5, I have a dentist appointment at three. So after I hit the post button. I'm gonna do a single refresh on all four to see web stats. After that I'll let everything be til probably around 4pm when I get back. If everything looks good, I'll leave them all on 237.5 for 24hrs.
If after that, everything still looks good. Then about this time tomorrow or so I will take the proverbial plunge and try 250 on one of them for 24hrs. If that holds good, then I'll set the second at 250 and let run 24hrs, so on and so forth til I t all four on 250 if I'm lucky.
Between 237.5 & 250, is there any other freqs, I think I saw someone say 240 or something a few pages back.
My curiosity is in tthe avg speed of miners 1 & 3 while 2 & 4 look good. Haven't done the HW% math, maybe someone could for me ? lol.
Oh ya, all four are OC'd to 237.5
About this time tomorrow I'll use actual pics when it will be ~24hrs that they will all have been up on 237.5.
https://bitcointalksearch.org/topic/ms-miner-antsp-monitor-v52-alertsautomassscheduled-rebootmobile-miner-596178
Try Ant Monitor. Its pretty useful. It will tell you your HW% and you can set up alerts. Use the S1 settings when setting up.
I made mine wireless and I connect through the router. I can jump on any computer in the house and monitor it.
Edit: https://bitcointalksearch.org/topic/m.8062114
After you connect it just treat it like an S1 and you can set up the wireless. Once you connect to the wifi it will be named WWAN by default. Go to WAN and change it to DHCP client and save and apply it. Disconnect the wire and turn the power off and on.
I reserved the DHCP on my router for the Antminer's MAC address so it will always have that IP.
. I replaced the thermal paste for all the chips and only had enough left over for one of the heat sink in the back. You can see the temp difference of replacing the thermal paste. I used Antec F7 since I didn't want to wait for the MX-4 to arrive in the mail. The room is about 23.3C and the fan rarely goes above 1700.
