No, but I did find with my 4 VRM one that putting the volts up too much turned the core off like your Die 2 is showing.
Is that what your trying to do? Get Die 2 up and running?
yep this is what i am trying. it would be very nice if you could share your settings.
Hmm, I'd reset it all to default, what are your individual die voltages at default? Mine are -0.1121V on all dies. You can get it back to defaults by hitting "Reset to Factory Defaults"
Then just increase ASIC1 - Die2 by 0.01V increments till you get to 0 leaving it for a few minutes at a time. I didn't have a completely dead die, well I didn't when I started, but I stopped a few dies by overvolting them, but got them back by putting it back to defaults and being more cautious.
It takes time, I had putty open in the screen session watching for cores disabling and bertmod in one browser to confirm what die the core disabled, then I would tweak the voltage on that die little bit by little bit until it came back on again. Then the waiting game for more dies to turn off, etc etc.
Similar patience is needed when overclocking CPU/GPU/Memory for benchmarking. A PITA to do while its happening, but very satisfying when you get it working.
Of course you may just have a terminally faulty module, which you will have to RMA
i think this board needs a RMA
. this are the default values:
my two other modules looks like the second on the picture.
