things arent looking good here right now, ive got 6 boards put together, ive tried to different controler boards and i cant find the jupiter on my network, using advanced ip scanner
does the bright white LED light come on for a few seconds about 30 seconds after startup? what lights do/do not come on?
grrrr.... dude..... if no lights....
You have nothing to lose by trying the cold-heat pen on solder points... it may work fine after 5 minutes "on the bench"
Please, the "cold-heat pen" comments are getting repetitive. Most people aren't going to do this as it would certainly void the warranty. I'm glad you love your pen but please stop.
Besides, the controller boards components aren't generally bad. There are helpful posts on the KNC forum addressing the problems with the controller boards.
Read this post for controller board troubleshooting...
http://forum.kncminer.com/forum/main-category/hardware/42074-3th-s-jupiter-troubleshooting-guideController board problems:
If you cannot access your controller board/beaglebone. Please follow the below instructions.
If you cannot access the beaglebone through web or SSH, it is most likely due to corrupt firmware, you will need to re-flash your beaglebone
Here are the instructions you need to re-flash your beaglebone:
Please download the following file:
https://www.kncminer.com/userfiles/f...age_0.99-E.zip and follow the instructions below.
1) Copy the ZIP file to an SD card and unzip the content of the archive on to the micro SD card formatted with FAT file system.
2) Turn the miner off via the power supply off switch and disconnect from the wall.
3) Open the case of the miner.
4) Insert the micro SD with the recovery files on it in to the SD card slot on the controller board
Note: to insert the micro SD card into the slot it might be necessary to unplug the flat cables which connect the ASIC boards to the controller board.
5) Reconnect the power supply and turn the power on.
6) Please wait while internal MMC flash memory is reprogrammed there will be a sequence of LED as follows:
1,2,3,4 blue LEDs on the BeagleBone will turn on, then bright white LED inside the case turns on for several seconds and then the red + green LEDs on the control board are on this means that the programming is in progress. When only the green LED is on for 5 seconds this means that the recovery was successful then all LEDs should go off and it means that the procedure completed.
7) Turn the miner off again and disconnect from the wall.
Eject the micro SD card from the controller board.
9) Plug in all the cables that were unplugged and ensure that they are secured.
10) Reconnect the power supply and power on. The miner should then start from the on-board MMC flash with the software revision 0.9.9-E
11) Install the latest firmware if you can access the miners interface:
https://www.kncminer.com/userfiles/f...miner-1.01.binIf your miner is still inaccessible:
Note: If you still cannot access the interface, please disconnect each ASIC board and then try to access the interface. If you can access the interface without any ASIC boards connected, you will most likely then have an ASIC board which is causing this issue. Please then connect these individually until you find the problem board. Once you have found a problem board, please let us know.
