Topic: █▓▒░-&lt; [ZPOOL.CA][BTC Multipool] The miners multipool &gt;-░▒▓█ Paid 925+ BTC - page 92. (Read 217686 times)

Quote from: tbearhere on May 14, 2016, 03:35:58 PM

I have KBomba version of Minercontrol and his profit chart. StuffOfInterest made the original.
On the MC it shows the signals rate real time and nicehash throws out a lot of high payout signals for 1 minute to get auto miners to switch there...then the price drops to real time and miner is locked there for what ever settings you have except ..... MC It calls them outliers and bypasses them. Wink

The auto pools do it once in a while but at a realistic price.

yep, partially that's why i don't test anything multi-algo - it's a tricky shit.
but comparing algo profitability is relatively objective

Yup and in constant flux.

tbearhere

legendary

Activity: 3164

Merit: 1003

Quote from: AngryDwarf on May 14, 2016, 03:16:13 PM

well my 24h+ testruns are over and i might say those 25-30% higher profitabilities
reported on zpool are non-existent, i get very similar btc from nicehash and zpool
the same algo (qubit, quark, x11).
so in the end block % is much closer to reality than shares %, not technically but for practical calcs.
unfortunately it seems impossible to construct a formula or even a good estimate
since zpool and NH use so different approaches

Based on a recent short multi-algo test on NH, I'd say zpool far outstrips NH, but maybe that can change with supply and demand of orders.
There are definitely some figures that don't seem to add up on zpool, whereas hashpower didn't seem to have the same problem. The latter pool though looks like it needs putting out of its misery at times.

it's important - i didn't run multi-algo, i ran one-algo per test on both,
just to see what really means if NH reports 0.15 and zpool 0.21,
but actually i get almost the same amount of btc.
i started that only because of those strange share % discrepancies

I have KBomba version of Minercontrol and his profit chart. StuffOfInterest made the original. https://bitcointalksearch.org/topic/ann-miner-control-161-auto-profit-switching-miner-controller-769239
On the MC it shows the signals rate real time and nicehash throws out a lot of high payout signals for 1 minute to get auto miners to switch there...then the price drops to real time and miner is locked there for what ever settings you have except ..... MC It calls them outliers and bypasses them. Wink

The auto pools do it once in a while but at a realistic price.
Talking about profits .... down they go. Grin

I really should delete this info.

AngryDwarf

sr. member

Activity: 476

Merit: 501

Quote from: tbearhere on May 14, 2016, 02:36:17 PM

well my 24h+ testruns are over and i might say those 25-30% higher profitabilities
reported on zpool are non-existent, i get very similar btc from nicehash and zpool
the same algo (qubit, quark, x11).
so in the end block % is much closer to reality than shares %, not technically but for practical calcs.
unfortunately it seems impossible to construct a formula or even a good estimate
since zpool and NH use so different approaches

Based on a recent short multi-algo test on NH, I'd say zpool far outstrips NH, but maybe that can change with supply and demand of orders.
There are definitely some figures that don't seem to add up on zpool, whereas hashpower didn't seem to have the same problem. The latter pool though looks like it needs putting out of its misery at times.

AngryDwarf

sr. member

Activity: 476

Merit: 501

Quote from: AngryDwarf on May 14, 2016, 02:19:00 PM

Does anyone know if the password length limit has been increased on ccminer? All these new algos to add.....

Not that I know of AngryDwarf....but right now I'm using a conf file.

So what does a ccminer conf file look like, or are you using minercontrol or something?

tbearhere

legendary

Activity: 3164

Merit: 1003

Quote from: AngryDwarf on May 14, 2016, 02:19:00 PM

Does anyone know if the password length limit has been increased on ccminer? All these new algos to add.....

Not that I know of AngryDwarf....but right now I'm using a conf file.

tbearhere

legendary

Activity: 3164

Merit: 1003

well my 24h+ testruns are over and i might say those 25-30% higher profitabilities
reported on zpool are non-existent, i get very similar btc from nicehash and zpool
the same algo (qubit, quark, x11).
so in the end block % is much closer to reality than shares %, not technically but for practical calcs.
unfortunately it seems impossible to construct a formula or even a good estimate
since zpool and NH use so different approaches

Looks like it.

AngryDwarf

sr. member

Activity: 476

Merit: 501

Does anyone know if the password length limit has been increased on ccminer? All these new algos to add.....

tbearhere

legendary

Activity: 3164

Merit: 1003

I haven't been able to read the thread for a week.
Question is.. is the pool sending out a false high pay rate on blake2s and blakecoin algo's ?
Miner control is saying to mine them at a very high price.
Should I take them out of my conf file ?
Thx

seeks88

newbie

Activity: 14

Merit: 0

Quote from: JaredKaragen on May 14, 2016, 08:59:51 AM

Quote from: crackfoo on May 14, 2016, 08:41:05 AM

why my coin reward percent is less than my share rate?my share rate is about 1.5%,but my reward percent is only 1%.......

Quote from: JaredKaragen on May 14, 2016, 08:59:51 AM

that doesn't explain, it's always lower

because larger amounts of hashrates can come in during the same period.... a spike in high hashrate is a typical explanation.

let's just say i saw different readings on yaamp and hashpower,
percent wasn't always lower than shares,
besides i tested that here on myr-gr when no spikes at all were observed (2-3 miners),
crackfoo ?

This pool pays out about 15-25% less than it should. I've been mining decred on it for a week and I haven't been paid out above what I should have been. Not once. Always under. The fact that crackfoo linked that post about fluctuating hashrate vs pool hashrate is laughable. I'm sorry, but the more I read on this thread the more I begin to doubt that this is a mistake made out of ignorance.

The miner's avg hashrate can be checked at any time via the graph readout on the wallet page. The pool hashrate can be checked at any time via its graph. These can easily be compared and a consistent discrepancy can be found.

My shares contributed per block mined are always %15-25% lower than they should be. This doesn't happen at any other pool.

ustcstone

newbie

Activity: 49

Merit: 0

Quote from: crackfoo on May 14, 2016, 08:41:05 AM

why my coin reward percent is less than my share rate?my share rate is about 1.5%,but my reward percent is only 1%.......

that doesn't explain, it's always lower

because larger amounts of hashrates can come in during the same period.... a spike in high hashrate is a typical explanation.

but the pool hashrate is not always increased,it's up and down during all time,let's say 24 hours.but in this 24hours, my rewards are always less than my sharerate.any time i check,it's lower.

http://zpool.ca/?address=1BEkEmVCuGhxiGpRusBB9jf8Wp77m7D5tH you can check it yourself

JaredKaragen

legendary

Activity: 1848

Merit: 1166

My AR-15 ID's itself as a toaster. Want breakfast?

Quote from: crackfoo on May 14, 2016, 08:41:05 AM

why my coin reward percent is less than my share rate?my share rate is about 1.5%,but my reward percent is only 1%.......

that doesn't explain, it's always lower

because larger amounts of hashrates can come in during the same period.... a spike in high hashrate is a typical explanation.

crackfoo

legendary

Activity: 3486

Merit: 1126

why my coin reward percent is less than my share rate?my share rate is about 1.5%,but my reward percent is only 1%.......

Quote from: JaredKaragen on May 14, 2016, 07:08:43 AM

ustcstone

newbie

Activity: 49

Merit: 0

why my coin reward percent is less than my share rate?my share rate is about 1.5%,but my reward percent is only 1%.......

JaredKaragen

legendary

Activity: 1848

Merit: 1166

My AR-15 ID's itself as a toaster. Want breakfast?

Neoscrypt Blake2s and X17 i see them the most presently.... When machine #3 was on in sf, it would see reject rates regularly on X11; it was a GTX650 just on the x11 port. You can see the wild differences in my coin payouts on my wallet page: http://zpool.ca/?address=1PHSDYvVp6HpqtuUPocK41DrdeHbbezaeP Hashrate says to me that something is goin awry.

Apparently the hashrates are good enough on my GTX980 that its been keeping me on X17 mostly, so im not hitting X15 and X13 as much as I used to before it was added.

presently testing the new algo for a block or two. see how it fairs =)

FWIW: I pulled myr-gr and groestl from my batch file because my machine would get stuck on them and the profitability chart showed me they weren't earning like the others.

crackfoo

legendary

Activity: 3486

Merit: 1126

crackfoo, any idea why the reject rate is getting so high recently? I have even defaulting to letting stratum decide my diff itself; and it still hasn't helped.

Lots of times its 33-70%; and I see it in my profitability on each coin generated. My system is steady going, but the pool is giving rewards all over the place.

Which algo's do you see are most problematic?

JaredKaragen

legendary

Activity: 1848

Merit: 1166

My AR-15 ID's itself as a toaster. Want breakfast?

crackfoo, any idea why the reject rate is getting so high recently? I have even defaulting to letting stratum decide my diff itself; and it still hasn't helped.

Lots of times its 33-70%; and I see it in my profitability on each coin generated. My system is steady going, but the pool is giving rewards all over the place.

JaredKaragen

legendary

Activity: 1848

Merit: 1166

My AR-15 ID's itself as a toaster. Want breakfast?