Topic: Bitmain introduces the Antminer S17 Pro, Antminer S17, and the Antminer T17 - page 11. (Read 11304 times)
June 27, 2019, 05:46:10 AM
direct from bitmain - was 1200 and change shipped.
June 27, 2019, 05:28:25 AM
My T17 is scheduled to be here this Friday - at least that is what DHL just texted me.
Congratulations!
To whom did you buy it? I've been looking around, and just found a lot of scammers like sellers.
Can you share with me your provider?
Thanks.
June 26, 2019, 01:31:54 PM
My T17 is scheduled to be here this Friday - at least that is what DHL just texted me.
June 26, 2019, 11:45:28 AM
The top numbers for power draw that I marked in red use as much as 3300 watts so 20 amp is needed to be safe.
Note that is pro model in a hot room on turbo 3371 watts.
Lastly 200 to 240 volts. Means my garage is out as it can drift up to 245 volts.
My spot in Clifton NJ is better 226 to 229 watts.
Note that is pro model in a hot room on turbo 3371 watts.
Lastly 200 to 240 volts. Means my garage is out as it can drift up to 245 volts.
My spot in Clifton NJ is better 226 to 229 watts.
What happens if voltage goes above 240?
Mine ranges from 117-123 on the 120 volt side. It was about 118 when I measured 237 on the 240 volt circuit.
June 18, 2019, 09:27:36 PM
Not too mention the fact your without a miner for a week to 3 weeks easily...
June 18, 2019, 08:44:22 PM
Let us know if you need a shipping label or at least check out pricing.
June 18, 2019, 08:16:38 PM
Plus shipping back and forth!! Likely $200
June 17, 2019, 10:18:35 PM
Sent the log to Bitmain, They told me to send the whole thing back.......they won't tell me what exactly is wrong with the machine. They just said its defective.
sending back sucks though. so much lost time and btc
June 17, 2019, 10:16:24 PM
Sent the log to Bitmain, They told me to send the whole thing back.......they won't tell me what exactly is wrong with the machine. They just said its defective.
June 17, 2019, 12:15:28 PM
They sell spare ones for the s15 and t15.
June 17, 2019, 11:09:56 AM
AFAIK in the interest of squeezing all the efficiency possible from a miner these are all using the PSU to regulate the Vcore applied to the chip strings. Losing the on-board regulators saves 5% power loss or more per-board. That means the only way to replace the PSU yourself is by using an exact replacement that has the connections needed for remote voltage control or sensing.
So is an integrated PSU a good idea? With everyone screaming for higher THs/J, yes.
So is an integrated PSU a good idea? With everyone screaming for higher THs/J, yes.
Well i was thinking to use the same PSU from the other T17s for testing... So yes, the same Bitmain PSUs, But don't worry, where there is demand, there might be a supply, all it takes is a psu manufacturer (or customer custom order) psus intended for the latest miners.
June 17, 2019, 10:57:21 AM
AFAIK in the interest of squeezing all the efficiency possible from a miner these are all using the PSU to regulate the Vcore applied to the chip strings. Losing the on-board regulators saves 5% power loss or more per-board. That means the only way to replace the PSU yourself is by using an exact replacement that has the connections needed for remote voltage control or sensing.
So is an integrated PSU a good idea? With everyone screaming for higher THs/J, yes.
So is an integrated PSU a good idea? With everyone screaming for higher THs/J, yes.
June 17, 2019, 10:48:23 AM
So..........one of my T17s just died today....about 2 weeks into operation. Apparently having an integrated PSU is NOT A GOOD IDEA!
The miner is fine, but the PSU blown a fuse or something. total of 10 miners, 1 already blew a PSU 2 weeks into operation.
Hope the S17s fare a bit better.
The miner is fine, but the PSU blown a fuse or something. total of 10 miners, 1 already blew a PSU 2 weeks into operation.
Hope the S17s fare a bit better.
Well you can technically replace the psu, but since you are till under warranty and unless they explicitly tell you to, send back the whole thing...
Ambient temperature and humidity readings at the time of the event would be useful to know if possible.
June 17, 2019, 05:26:50 AM
My power is always 230
The T17s don't let you choose the speed, its just on normal.
curiously, This came up when I was trying to send some screenshots back to Bitmain
The T17s don't let you choose the speed, its just on normal.
curiously, This came up when I was trying to send some screenshots back to Bitmain
Code:
[FATAL TAG] Fixture CRC check fail.
2019-06-17 10:17:32 pic.c:227:hashboard_power_cntl: failed on Chain[0]! read_back_data[0] = 0x0, read_back_data[1] = 0x0
2019-06-17 10:17:33 pic.c:227:hashboard_power_cntl: failed on Chain[0]! read_back_data[0] = 0x0, read_back_data[1] = 0x0
2019-06-17 10:17:35 pic.c:227:hashboard_power_cntl: failed on Chain[0]! read_back_data[0] = 0x0, read_back_data[1] = 0x0
[FATAL TAG] Fixture CRC check fail.
2019-06-17 10:17:38 pic.c:227:hashboard_power_cntl: failed on Chain[1]! read_back_data[0] = 0x0, read_back_data[1] = 0x0
2019-06-17 10:17:39 pic.c:227:hashboard_power_cntl: failed on Chain[1]! read_back_data[0] = 0x0, read_back_data[1] = 0x0
2019-06-17 10:17:41 pic.c:227:hashboard_power_cntl: failed on Chain[1]! read_back_data[0] = 0x0, read_back_data[1] = 0x0
[FATAL TAG] Fixture CRC check fail.
2019-06-17 10:17:44 pic.c:227:hashboard_power_cntl: failed on Chain[2]! read_back_data[0] = 0x0, read_back_data[1] = 0x0
2019-06-17 10:17:45 pic.c:227:hashboard_power_cntl: failed on Chain[2]! read_back_data[0] = 0x0, read_back_data[1] = 0x0
2019-06-17 10:17:47 pic.c:227:hashboard_power_cntl: failed on Chain[2]! read_back_data[0] = 0x0, read_back_data[1] = 0x0
June 17, 2019, 04:28:19 AM
So..........one of my T17s just died today....about 2 weeks into operation. Apparently having an integrated PSU is NOT A GOOD IDEA!
The miner is fine, but the PSU blown a fuse or something. total of 10 miners, 1 already blew a PSU 2 weeks into operation.
Hope the S17s fare a bit better.
The miner is fine, but the PSU blown a fuse or something. total of 10 miners, 1 already blew a PSU 2 weeks into operation.
Hope the S17s fare a bit better.
What is your typical power in volts?
210
220
230
240
what speed was it on?
high
low
June 17, 2019, 03:35:26 AM
So..........one of my T17s just died today....about 2 weeks into operation. Apparently having an integrated PSU is NOT A GOOD IDEA!
The miner is fine, but the PSU blown a fuse or something. total of 10 miners, 1 already blew a PSU 2 weeks into operation.
Hope the S17s fare a bit better.
The miner is fine, but the PSU blown a fuse or something. total of 10 miners, 1 already blew a PSU 2 weeks into operation.
Hope the S17s fare a bit better.
May 31, 2019, 10:59:42 AM
New firmware for the 17 series.
Pro:
https://service.bitmain.com/support/download?product=Antminer%20S17%20Pro
Normal:
https://service.bitmain.com/support/download?product=Antminer%20S17
If you have the April 16th or earlier firmware, you need to flash the intermediate update from 5/24, then do the 5/27 one.
On Turbo, my gains from went up about 60 GH with this update after evaluating the 24 hour hashrate. That's like a third of a S1
Pro:
https://service.bitmain.com/support/download?product=Antminer%20S17%20Pro
Normal:
https://service.bitmain.com/support/download?product=Antminer%20S17
If you have the April 16th or earlier firmware, you need to flash the intermediate update from 5/24, then do the 5/27 one.
On Turbo, my gains from went up about 60 GH with this update after evaluating the 24 hour hashrate. That's like a third of a S1
May 27, 2019, 09:17:00 AM
when they do come up for sale it is usually around 12am to 2am Eastern time for me and they dont last long - maybe 2 hours tops, sometimes they are sold out in less than 20 minutes.
Smaller batches lots of resellers eating them up. Best to plan ahead or find a trusted vendor.
May 25, 2019, 08:09:53 PM
I am checking Bitmain shop website several times a day, but I have never seen availble units yet 
So I'd like to know how can I reach few units of Antminer (not necessarily T17/ S17 but any of newest products)
BTW do I see correct that first batch will be dispatched in June or was it any T17/S17 already sent?
So I'd like to know how can I reach few units of Antminer (not necessarily T17/ S17 but any of newest products)
BTW do I see correct that first batch will be dispatched in June or was it any T17/S17 already sent?
when they do come up for sale it is usually around 12am to 2am Eastern time for me and they dont last long - maybe 2 hours tops, sometimes they are sold out in less than 20 minutes.
May 25, 2019, 07:13:50 PM
I am checking Bitmain shop website several times a day, but I have never seen availble units yet
So I'd like to know how can I reach few units of Antminer (not necessarily T17/ S17 but any of newest products)
BTW do I see correct that first batch will be dispatched in June or was it any T17/S17 already sent?
So I'd like to know how can I reach few units of Antminer (not necessarily T17/ S17 but any of newest products)
BTW do I see correct that first batch will be dispatched in June or was it any T17/S17 already sent?
Many people have the first batch of s17s mining in house myself included.
I have been using mine for 8 days.
Jump to: