Topic: Dayun Zig Z1 - Lyra2Rev2 6.8GH/s Asic miner - page 4. (Read 42511 times)

I'm getting 11,000 mh/s on nicehash, all boards working.

another question!


What hashrate do you have  with the Z1Pro?

I have about 10050 MH/s...
(only 7 of 8  Units working 😥still the same... ) coukd somebody help?

I used 2 antimatter PSUs and all the connections are the same as long as you don't power a board with 2 different PSUs you are good to go.

Hi,

Anyone knows how to connect the Zig Z1 Pro to the power supply?

There is no manual at their website zigminer.com, my package from Coin Mining Central also contains no manual...

Thanks
Vinncent

Yes I made an update.. I made the hotfix_07_05... but i didn't see any changes!
Better was that I checked  the contacts... some data cable were  not really fixed, I guess...!

At the end 7 of the 8 Units  are working and iam quite happy... when it's running it's runs!
in average  10040 MH/S ( nicehash shows) also in my minermenue!
only 0.01 - 0.02 Error Percentage

still one other issue: when I stop the miner.. I have to plug of 1 or 2 units from PSU, after that  and only then it's starting!
who has the same issue? and what could be tbe reason?
to much power of PSU?

I tried to reduce Starting Frequenz from. 700 to 650 MHz or 600 MHz
then I need only to plug of one Unit!


What could be wrong....?

i would have guarantee for 6 months.
but sending back to China... not profitable I guess.. hmmmm

@jaxl

Default is 192.168.1.100

@bigcoin8

I am having issues as well.  You ever get a new firmware flashed?

just got my zig z1 pro in yesterday and it will not show up on my network tried going to 192.168.0.100 and nothing when i plug it in the red light stays on for a bit then goes out and the only lights on are the port lights any help would be appreciated

Mona addresses starts with the letter "M"....

I have the Z1 Pro and it will no mine on any pool expect nicehash.  Any ideas?


NO   Pool   Type   Status   Pool HR   AC   RE   Username
0   stratum+tcp:// pool.minerall.io:3501   active   Dead   0GH/s   0   0   mona1qxa2tffltlvxu97f######y7asdu2.Z1Pro
1   stratum+tcp://mona.f2pool.com:20593   active   Dead   0GH/s   0   0   mona1qxa2t&&&&&&&&7asdu2
2   stratum+tcp://lyra2rev2.usa.nicehash.com:3347   active   Alive   12.48GH/s   2683   54   &&&&&&&&&&

Iam having increasing troubles with these miners im pretty sure it is software. I have made numerous usb back ups and rewrites one miner runs fine whilst the other runs for a few days and starts faulting. with the good miner i have made an image from it but it is now over 15gb where as all the others have been under 8Gb. is there a dump or such file i can delete to get it down to a smaller size or is my best bet going to be start fresh? Iam still  using the 930 update as this was the last one where overclocking actually worked.

Thanks.

Much better! The model in question also does not exist. I think there is a D1 model but I think it is x11 or another protocol.

I gave you merit for this post.

I'd suggest before you ACTUALLY put up links to the equipment you go thru www.bitcointalk.org threads. Do a google search of whatever the supposed company or

product is with bitcointalk.org added, this should show you a thread on the company and/or do the product model. Then at least you can see the Bitcointalk threads

of people discussing the validity of the company and or the equipment. Then go from there I guess.

Thanks for listening.

Brad

edit: Also took a chance and gave your newbie account a trust rating of +1 , so don't disappoint on your calcuator project. You may want to look into a bronze plan on bitcointalk

I think it is around 40 buck in usd of Bitcoin, to get around some of the newbie restrictions on gaining rank...what I would do as a newbie on bitcointalk. Just saying.

Thank you sir! Does it better?
https://cryptocalc.online/en/miners/dayun-zig-d2

er...sorry to burst you scammer bubble. But IF this is this site (the calculator site https://cryptocalc.online/en/miners/dayun-zig-d2?powerCost=0.1&symbol=MONA

the above dayunmining.com is still shown..which IS a scam site. Again, if this is what you are refering to the link is still there on the english page.

If again, you are saying the calculaor link,  by your reply. IF SO DON'T READ BELOW THAT APPLIES TO THE SCAMMER SITE IF THAT IS WHAT THIS POST MEANS.

---------------------

If you are refering by your post that the scammer site IS legit with your newbie account I say Bullsh*t!


Dayun site above says it has a 240gh miner. I don't believe it. The site does not support this and there is NO info on this site and equipment of any real note.

This site cropped up 'last year' see the scam site thread on Bitcointalk here: 

https://bitcointalksearch.org/topic/zig-z1-wwwdayunminingcom-is-a-scam-website-5138450

It will take more than a NEWBIE ACCOUNT for folk to fall for this.

You have my email, I threw down a challenge, send me a unit, I'll review it, if it is legit I'll even pay you

the BTC you want on your page (now from 2.3k to 2.8k). But only if it 1) exists and 2) works as advertised. 3) hell even then if group buy I'd likely need escrow

No way, IF YOU ARE LEGIT are you likely to get a toe hold on selling these miners via bitcointalk and the USA proper without some put up or shut up proof.

Look at my profile, I've done escrow for innsilicon group buys before, I have a +22 trust rating, again, you have my email, fill free to pm me here or email me

I get the unit, I review this supposed 240gh unit, I happily eat crow if it works and pay you and then hell..you are off to the races.

But naw, so far it all screams scam, (re-read above why I wasted 5 min of my life replying to this when the odds are the same as if this is legit of me being

Natalie Portman's Love Puppet is beyond me)

Whatever, moving on. (I have no life 4th of July in the USA and I'm playing verbal tag with likely scammers..sheesh...I need a life!)

Brad

THIS IS NOT A SCAM SITE.
We constantly work to make this site better. All links to SCAM SITE (http://www.dayunmining.com/) has been removed.
Thank you for your attention!
Also we want to remove all zero value exchange coins from list to make the profit value more realistic.
Thank you and sorry for that incident.

yeah...I did not order any scam miners...but it is 'specifically' the Dayun D4 which does not exist . FYI.

again the above cryptocalculator pointed me there but the amount per day was screwy 300 a day..so looked at site a scam (or we are all missing the boat!)

later

Brad

These two are legit:

https://asicminermarket.com/product/dayun-z1pro-13gh-s-miner/
https://www.akminer.com/all-products/dayun-z1-pro-ship-before-6th-july

Don't go by this calculator it lists the scam site.

THIS IS A SCAM SITE CALCULATOR HAS FAKE DAYUN LINK:  https://cryptocalc.online/en/miners/dayun-zig-d2?powerCost=0.1&symbol=MONA

Here is the scam site for Dayun. Again THIS IS THE SCAM SITE FOR DAYUN MINERS LINK:  http://www.dayunmining.com/

Again, above is A SCAM SITE AND THE OTHER IS A CALCULATOR THAT LINKS TO SCAM SITE above. You have been warned.

On the other hand, just for reference, what is the LEGIT MANUFACTURER SITE, even if you can't buy from them directly? I'd like to see the site where this is made, even

if I do need to use Google Translate Chinese.

The ONE site I know that is legit that carries Dayun stuff is of course www.eastshore.xyz

They are legit and usually are a bit higher in price, but hey, something.

Doubt I'll get one, but was tooling around the Internet and tripped over the above links that show treachery and scam sites (above) figured I'd post here

later

Brad

Did you try different USB Flash disc? I just today replaced the original after three previous fails and now it works again.

thanks bro but these not 300918. ı have 300918 for z1+ , ım was use 9 mounth but now its stoped. miner not boot writing. why ı dont know. 

6 Months.... No new firmware

Last time He post.
December 05, 2018, 05:43:44 PM